User manual BLAUPUNKT LIMA CR 47

[. . . ] Radio / Cassette Lima CR 47 Operating instructions Table of Contents Features . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 19 Traffic Safety and Precautions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 19 Detachable Face (Release Panel) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 20 Electrical Connections . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Make sure the unit is firmly anchored and does not vibrate. · Mounting Hardware Sleeve Release Keys Mounting The Unit in Most Dashboards 1. Select and bend the appropriate tabs to hold the sleeve firmly in place. Bend these tabs 23 PORTUGUÊS ESPAÑOL SVENSKA NEDERLANDS ITALIANO FRANÇAIS ENGLISH DEUTSCH Installation Mounting the Unit in a Japanese Car You may have difficulty mounting this unit in some Japanese cars that have ISO mounting features. In this case, consult your Blaupunkt dealer. Run a blade along the slits on the back of the front trim ring, unscrew the two side screws, and separate it from the unit. Save the trim ring and related hardware in case you ever want to install the unit in another vehicle. Use the vehicle's own mounting hardware to attach the unit. 1 Slit 2 TOYOTA max. size M5x8 to dashboard/center console max. size M5x8 Bracket Support 2 NISSAN max. size M5x8 to dashboard/center console max. size M5x8 Bracket Support 24 Removing the Unit ITALIANO PORTUGUÊS 25 Use the Release Keys as shown below. Keep them in a safe place in case you need them in the future. Fuse Replacement When replacing the fuse, be sure to use one with the correct amperage, which will be stated on the fuse case. Never use a fuse that has a stated amperage exceeding the one supplied for this unit, as this could cause malfunction and serious damage to the unit. ESPAÑOL SVENSKA NEDERLANDS FRANÇAIS ENGLISH DEUTSCH Maintenance Location of Controls 1 2 3 4 5 REL (Release) ON (Power) SRC ­ Detaching Faceplate ­ Turning Unit On ­ Source and Radio Band Select ­ Cassette Eject ­ Mute AUDIO 6 7 8 9 SCA TS LD SENS CLK DISP 10/11 PROG 10 11 12 13 14 15 16 17 1, 2, 3, 4, 5 Display FR FF + ­ ­ Audio / Clock Adjust :00 ­ Scan ­ Travelstore ­ Loudness ­ Tuning Sensitivity ­ Clock Recall ­ Display Change ­ Tape Program Change (reverse) ­ Fast Rewind ­ Fast Forward ­ Volume + / Bass + / Treble + / Balance Left / Fade to Front ­ Volume - / Bass - / Treble - / Balance Right / Fade to Rear ­ Seek and Manual Tuning / Clock Hours ­ Seek and Manual Tuning / Clock Minutes ­ FM/AM Presets Cassette Insertion Slot 26 See Traffic Safety and Precautions on page 19. "Press" means a momentary press of less than 1/2 second. All presses requiring more than 1/2 second are followed by beep. "Time Out" When additional button presses are anticipated to complete a procedure, the unit will automatically exit the procedure after 4 seconds of inactivity. Clock Recall Vehicle ignition must be on. Ignition-On / Turning Unit Off Press the ON Button to turn the unit off. Release for Detachable Faceplate Push REL to detach face. Already inserted cassette remains in unit. Current settings and source mode are stored. If power was not switched off before face removed, unit will automatically power-on when face is reattached. Power On/Off When ignition on, press ON or insert a disc to turn unit on. Last-used source becomes active, unless unit is turned on by inserting tape, in which case tape player becomes active. Unit stores current settings for source, station or track, etc. [. . . ] If unit already turned on, cassette insertion will override other audio source, such as radio. Cassette play will begin, and the display will indicate which tape program is in use, "1" or "2". · The tape will continue to play until ejected, SRC button pressed, or unit turned off. Ejecting The Tape Press the button completely towards the face of the unit. [. . . ]