User manual BLAUPUNKT LOS ANGELES CDM147

[. . . ] FCC Warning The equipment has been tested and found to comply with the limits for a Class B device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy, and, if not installed and used in accordance with instructions, may cause harmful interference with radio communications. However, there is no guarantee that radio interference will not occur in particular installation. [. . . ] Loudness level set under Menu and is source dependent. To cancel, press LD again. Radio Operation Once tuning is complete, radio display sequence follows. Last Station Memory Each FM bank and AM band has its own last station memory which holds last-tuned frequency for that band or bank irrespective of whether that frequency is stored into a preset. BND Button Press BND to access FM1, FM2, FM3/FMT, AM/AMT banks. When in radio mode, advances to next bank. When in other source, returns to last-tuned bank. 14 Seek Tuning Press /\ or V to seek next receivable frequency. Tuning stops at frequency that fulfills sensitivity requirements predetermined by sensitivity set through SENS/LD button. Press of /\ or V buttons for more than 1/2 second seeks next receivable frequency after button is released. Tuning Sensitivity (SENS) Press SENS/LD for more that 2 seconds to switch between lo and dx search sensitivity. Radio Reception Hints · When listening to weak or distant AM stations, adjusting the Treble to minimum (-7) will reduce noise and improve sound. · In general, set SENS to DX if in rural areas or where stations tend to be weak and distant, and to LO when in metropolitan areas or where stations tend to be strong and local. Stereo Symbol Stereo symbol turns on if a stereo station with an incoming signal of 20 dBµV is received. The unit gradually switches between mono to stereo automatically. Manual Tuning Press << or >> and frequency will go one channel/step in direction pressed. Press and hold causes continuous manual tuning. Preset Station Storage After tuning desired frequency on desired band, press and hold a Preset Button for more than 2 seconds to store current frequency. Audio is muted during storage, preset number appears, and beep acknowledges storage. No preset storage during seek, scan or Travel Store. Preset Station Selection Press desired Preset Button. Travel Store This feature allows you to automatically store stations onto all 6 preset buttons and is especially useful when traveling outside your normal listening area. In any FM Bank, press BND for 2 seconds to activate FM Travel Store. [. . . ] Choose disc that has name to be deleted. When name appears, press Mute for 2 seconds. "NAME" and "DELETED" alternately blink. Erasing ALL Disc Names Warning: THIS FEATURE ERASES ALL NAMES AND ASSOCIATED TRACK PROGRAM MEMORY FOR ALL DISCS, INCLUDING DISCS NOT PRESENTLY IN MAGAZINE. [. . . ]