User manual BLAUPUNKT LUCCA 3.3 LOW GR-CZ-POL-TK

[. . . ] RDS button to switch the RDS feature on/off. CD·C button to select CD, radio and CD changer (if connected) sources. 8 9 : ; < = > AUDIO button to adjust the bass, treble, balance and fader settings. MENU button to open the basic settings menus. TRAF button to switch traffic information standby on/off. [. . . ] The last settings (radio, CD, CD changer or AUX) will be reactivated. Switching on/off using button > To switch the unit on, press button >. To switch the unit off, press button > for longer than two seconds. The unit switches off. 29 ADJUSTING THE VOLUME Adjusting the volume The system volume can be adjusted in steps from 0 (off) to 66 (maximum). To increase the system volume, Instantaneous volume reduction (mute) This feature allows you to instantaneously reduce (mute) the volume to a level preset by you. press the press the button =. button =. To decrease the system volume, Briefly press button >. "MUTE" appears in the display. Setting the mute level You can set the unit's mute volume level. Setting the power-on volume You can set the default volume at which the unit switches on. Press the MENU button :. Keep pressing the or button 9 until "ON VOL" appears in the display. Press the MENU button :. Keep pressing the or button 9 until "MUTE LVL" appears in the display. Set the power-on volume using the and buttons 9. To help you adjust the volume more easily, the volume will be increased / decreased as you make your changes. If you change the setting to "0", the power-on volume will be the same as the volume level that was set before the unit was last switched off. Note: To protect your hearing, the poweron volume is limited to a value of "38". AF: If this RDS function is activated, the unit automatically tunes into the best receivable frequency for the station that is currently set. REG: At certain times, some radio stations divide their programme into regional programmes providing different regional content. You can 32 RADIO MODE DEUTSCH PORTUGUÊS ESPAÑOL SVENSKA NEDERLANDS ITALIANO FRANÇAIS ENGLISH Selecting the frequency range / memory This unit can receive programmes broadcast over the FM, MW and LW frequency ranges. Note: The MW and LW frequency ranges are not available on the Essen CD31. There are three preset memory levels for the FM range and one for each of the MW and LW ranges. Five stations can be stored on each memory level. Selecting the memory level To switch between the FM memory levels and the MW and LW frequency ranges, Setting the sensitivity of the station search mode You can configure the radio to only tune into stations with a strong reception or to also tune into those with a weak reception. Press the MENU button :. Keep pressing the or button 9 until "SENS" appears in the display. Press the button 9. keep pressing the FMT or BAND (TS) button 2 until the required frequency range / memory level is displayed. The display shows the currently set value for sensitivity. "SENS HI6" means that the tuner is highly sensitive. "SENS LO1" means it is set to the lowest sensitivity setting. If "SENS LO" is selected, "lo" lights up in the display. Set the required sensitivity using the and buttons 9. Press the MENU button :. Tuning into stations manually You can also tune into stations manually. [. . . ] Once the minutes are set, / or button 9 to switch between the displays. When you have finished making your changes, Press the press the button 9. press the MENU button :. Briefly displaying the time when the unit is switched off To briefly display the time when the unit is off, The hours flash on and off. When you have finished making your changes, Adjust the hours using the press the MENU ( ) button :. The time is displayed for around 8 seconds. press the MENU button : twice. [. . . ]