User manual BLAUPUNKT MPA 5

Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual BLAUPUNKT MPA 5. We hope that this BLAUPUNKT MPA 5 user guide will be useful to you.

Lastmanuals help download the user guide BLAUPUNKT MPA 5.


Mode d'emploi BLAUPUNKT MPA 5
Download

You may also download the following manuals related to this product:

   BLAUPUNKT MPA 5 annexe 1 (449 ko)

Manual abstract: user guide BLAUPUNKT MPA 5

Detailed instructions for use are in the User's Guide.

[. . . ] The amplifier's own fuse protects the amplifier itself, but not the car battery. Disconnect the negative terminal of the battery before carrying out installation and connection work. Observe the vehicle manufacturer's safety instructions (regarding airbags, alarm systems, trip computers, vehicle immobilisers). [. . . ] Never bridge fuses or replace fuses with a higher current rating. 7 Connection to car radios with ISO terminal using the Cinch jack . This enables the amplifier to be switched on and off with the radio's On/ Off switch. High-level inputs The amplifier is equipped with high-level inputs to permit connection to radios without preamp outputs (Fig. This enables direct connection to be made to the radio's loudspeaker output. Gain control The gain control enables the input sensitivity of the final stage to be matched to the output voltage of your car radio preamp output. Adjust the input sensitivity in accordance with the manufacturer's specifications when connecting the amplifier to other radios. important: Turning the gain control clockwise increases the input sensitivity of the amplifier , and thereby also the volume. The gain control is however not a volume control; an increase in volume is not achieved in the maximum position, even if this subjectively appears to be the case. The system merely increases the volume more quickly when the volume is turned up on the radio. Tri-mode loudspeaker connections MPA amplifiers can be used in a combined mono/stereo mode (Fig. This facility enables the amplifier to be uq°d simultaneously with stereo satellite speakers (mid-range and tweeter) and a mono subwoofer. The connections are somewhat more complicated in this case, as they require the use of passive crossover networks (not supplied with the amplifier) which divide the frequency ranges between the various loudspeakers. CAUTION: In tri-mode (combined mono/stereo mode) the amplifier must be presented with a load of at least 2 Ohms (stereo satellite speakers) or 4 Ohms (mono subwoofers). Lower loads cause overheating of the amplifier and may damage it permanently. loudspeaker connections (If the amplifier is to be connected in a bridged mode , proceed with the section "Bridged loudspeaker connections". ) As with any audio component, connection of the amplifier and speakers with the correct polarity is essential for good bass reproduction. This enables you to use the amplifier for one or more subwoofer(s) or a mid-range speaker. [. . . ] Bolt a standard commercial negative cable to a ground point free of induced noise (car body bolt, body panel) - not to the negative battery pole. Clean the contact surface of the ground point down to bare metal and coat with antiseize graphite petroleum. If, for example, you wish to drive a pair of subwoofers, connect in accordance with the low-pass diagram, . [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE BLAUPUNKT MPA 5

Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets...
In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.

Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual BLAUPUNKT MPA 5 will begin.

Search for a user manual

 

Copyright © 2015 - LastManuals - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.

flag