User manual BLAUPUNKT SANTIAGO CR 87

[. . . ] Radio / Cassette Santiago CR 87 Operating instructions Table of Contents Features . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 19 Traffic Safety and Precautions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 19 Detachable Face (Release Panel) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 20 Electrical Connections . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] In this case, consult your Blaupunkt dealer. Run a blade along the slits on the back of the front trim ring, unscrew the two side screws, and separate it from the unit. Save the trim ring and related hardware in case you ever want to install the unit in another vehicle. Use the vehicle's own mounting hardware to attach the unit. 1 Slit 2 TOYOTA max. size M5x8 to dashboard/center console max. size M5x8 Bracket Support 2 NISSAN max. size M5x8 to dashboard/center console max. size M5x8 Bracket Support 24 Removing the Unit ITALIANO PORTUGUÊS 25 Use the Release Keys as shown below. Keep them in a safe place in case you need them in the future. Fuse Replacement When replacing the fuse, be sure to use one with the correct amperage, which will be stated on the fuse case. Never use a fuse that has a stated amperage exceeding the one supplied for this unit, as this could cause malfunction and serious damage to the unit. ESPAÑOL SVENSKA NEDERLANDS FRANÇAIS ENGLISH DEUTSCH Maintenance Location of Controls 1 2 3 4 5 REL (Release) ON (Power) SRC ­ Detaching Faceplate ­ Power On/Off ­ Source and Radio Band Select ­ Cassette Eject ­ Mute AUDIO 6 7 8 9 SCA TS LD SENS CLK DISP 10/11 PROG 10 11 12 13 14 15 16 17 18 Display 1, 2, 3, 4, 5 FR FF + ­ ­ Audio ­ Scan ­ Travelstore ­ Loudness ­ Tuning Sensitivity ­ Clock Recall ­ Display Change ­ Tape Program Change (reverse) ­ Fast Rewind ­ Fast Forward ­ Volume + / Bass + / Treble + / Balance Left / Fade to Front ­ Volume - / Bass - / Treble - / Balance Right / Fade to Rear ­ Seek and Manual Tuning / Clock Hours ­ Seek and Manual Tuning / Clock Minutes ­ FM/AM Presets ­ Dolby B NR (Noise Reduction) Cassette Insertion Slot 26 See Traffic Safety and Precautions on page 19. "Press" means a momentary press of less than 1/2 second. All presses requiring more than 1/2 second are followed by beep. "Time Out" When additional button presses are anticipated to complete a procedure, the unit will automatically exit the procedure after 4 seconds of inactivity. Clock Recall Vehicle ignition must be on. Release for Detachable Faceplate Push REL to detach face. Already inserted cassette remains in unit. Current settings and source mode are stored. If power was not switched off before face removed, unit will automatically power-on when face is reattached. Power On When ignition on, press ON or insert a disc to turn unit on. Last-used source becomes active, unless unit is turned on by inserting tape, in which case tape player becomes active. Power Off Press ON for more than 1/2 second to turn the unit off. Unit stores current settings for source, station or track, etc. Press the CLK Button for four seconds until the clock starts blinking. (The display will change after two seconds. [. . . ] · The change in direction and in tape program will be confirmed in the display ("1" or "2"). Fast Winding · To Fast-Rewind the tape, press the FR Button. blinks in the · To Fast-Forward the tape, press the FF Button. · To stop fast-winding, press the other fast winding button, FR or FF. [. . . ]