User manual BLAUPUNKT THA 555 PNP

[. . . ] SUB Max power RMS power 1 x 400 watt / 4 1 x 200 watt / 4 Fig. Please observe the following safety notes during the installation and connection. - When you drill holes, ensure that you do not damage any vehicle components. - The cross section of the plus and minus cable may not be less than 2. [. . . ] Stereo mode Max power Max power RMS power RMS power Bridge mode Max power RMS power 4 4 4 4 x x x x 110 watt / 4 130 watt / 2 55 watt / 4 65 watt / 2 Fig. 5 The fuses integrated in the amplifier protect the power amplifier and the entire electrical system in case of an error. If a replacement fuse is used, never bridge fuses or replace them with a type with higher current. 2, 2a Connection to car sound system with cinch output . The Level control is used to adjust the input sensitivity of the power amplifier to the output voltage of your car sound system. A few important explanations in this context: By turning the control clockwise, the input sensitivity of the amplifier and, therefore, also the volume increases. However, this is not a volume control; no further amplifier output can be achieved in the end position, even if it may sound like that at the beginning. The system merely increases the volume faster if the volume control of the car sound system is turned up. This allows the amplifier to be switched on and off using the on/off-switch of the radio device. (If the amplifier is to be jumpered, continue with the section "Bridged loudspeaker connections" at this point). As with every audio component, the correct polarisation of amplifier and loudspeakers is of essentially importance for a good bass response. For this reason, ensure that the positive (+) connection of the amplifier is connected with the positive connection (+) of the loudspeaker; the same applies to the negative (-) connections. In addition, the left amplifier channel must be connected with the left loudspeaker and the right amplifier channel with the right loudspeaker. This allows the amplifier to be used for one or several subwoofers or a mid-range driver. In this configuration, the amplifier combines the right and left channel to a single-channel output (mono output). Note: The amplifier can add the right and left signal information only if the right as well as the left RCA connection were carried out. Caution: In a bridge circuit, the amplifier load must be 4 ohm or higher. A lower load leads to an overheating or switch-off of the amplifier and can cause permanent damages. [. . . ] Green LED: Output stage on, regular operating status. Red LED: Output stage is electronically switched off due to an error. Please use the return and collection systems available to dispose of the product. Låt oss bara till sist säga några ord om hälsoskydd: Tänk på om du lyssnar på musik i bilen att en långvarig ljudnivå över 100 dB kan leda till bestående hörselskador och till och med dövhet. [. . . ]