User manual BLAUPUNKT TP AMSTERDAM NAV35E WR D

[. . . ] 8/9 Use the connection wiring included with the CD player or the connection block. If necessary, also use cables 7 607 647 093 and 7 607 648 000. When using the IR remote control, QuickOut operation is not possible. [. . . ] When using the IR remote control, QuickOut operation is not possible. ConnectioninvehicleswithQuickOut In vehicles equipped with a QuickOut (currently Opel), the QuickOut unit must be removed and the adapter cable used. Installingthecarradio Place the car radio in the front of the mounting bracket and push it in until the side springs snap into position on the left and the right (you will hear an audible click). Removingthecarradio Insert the handles into the holes in the panel on the left and right of the radio and push them in until you hear a distinct click (unlocks side springs). Pull the unit out using both handles, see Fig. 3 Note:Handleswhichhavesnappedintoplacecanonlybe removedafteryouhavepulledtheradiooutofthe compartment. This information is subject to change without notice! In order to take advantage of the full car radio output and to avoid incorrect electrical connections with ISO plugs in the vehicle, it is advisable not to use the vehicle-specific positive/negative connection for this car radio. Also, the unit will automatically switch off after one hour of playback time to avoid that the battery goes flat. This hour logic will not be activated when connecting the permanent +12 V line (terminal 30). Do not connect the vehicle's positive line !5 mm2 cross section to the battery (do not route close to vehicle harnesses). Connect the fuse box to protect the positive line and hook up to the positive terminal of the battery. If necessary, drill a hole into the splash wall and use a cable duct as required. The control wire is the switched positive output for external pieces of equipment such as a power antenna, maximum load < 150 mA. The control wire is the switched positive output for external pieces of equipment such as an amplifier or equaliser, maximum load < 150 mA. [. . . ] The control wire is the switched positive output for external pieces of equipment such as a power antenna, maximum load < 150 mA. The control wire is the switched positive output for external pieces of equipment such as an amplifier or equaliser, maximum load < 150 mA. TelephoneMute(low) When connecting a phone, the car radio will be automatically muted when making a call. [. . . ]