User manual BLAUPUNKT TP DX-V NAV IBERIA

[. . . ] If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to contact the dealer or an experienced Radio/TV technician for help. You are cautioned that any changes or modifications not expressly approved in this manual could void your authority to operate this equipment. CAUTION · The use of optical instruments with this product will increase eye hazard. · Because the invisible laser beam in this compact disc player is harmful to the eyes, do not attempt to disassemble this cabinet. [. . . ] · Use this unit only with negative ground 12 Volt (11-16 Volt) direct current (DC). · Be sure to detach the faceplate before you start to connect or install the unit. · Don't assume that a seemingly matching wire harness in the vehicle has leads that match the leads of the unit's wire harness. · We recommend making and testing all electrical connections before installing the unit. Connect the leads (wires) according to instructions and diagram below. ELECTRICAL CONNECTION INSTRUCTIONS 1. Disconnect the vehicle battery's negative terminal before making connections. Connect the speakers and/or external amplifiers (if you have any) following the guidelines in the SPEAKER CONNECTION section below. Connect the blue (trigger output) lead to the amplifier's trigger input terminal and/or antenna motor trigger input terminal (if you have either or both of these items). The combined total amperage required for triggering the antenna motor and/or amplifier must not exceed 300 mA. DO NOT connect the blue lead to the antenna's and/or amplifier's power supply input. Connect the black (power ground) lead to a grounded metal part on the vehicle. This will prevent them from touching the vehicle or each other and causing a short-circuit and damage to the receiver or vehicle. size M5x8 to dashboard/center console max. size M5x8 Bracket Support 2 NISSAN max. size M5x8 to dashboard/center console max. size M5x8 Bracket Support 9 Maintenance Removing the Unit Use the Release Keys as shown below. Keep them in a safe place in case you need them in the future. Fuse Replacement When replacing the fuse, be sure to use one with the correct amperage, which will be stated on the fuse case. Never use a fuse that has a stated amperage exceeding the one supplied for this unit, as this could cause malfunction and serious damage to the unit. 10 Specifications Audio Power Specifications Power Output and Total Harmonic Distortion: 13 watts per channel minimum continuous average output into 4 ohms, 4 channels driven, from 30-15, 000 Hz with no more than 1% total harmonic distortion. Other Specifications Tuner FM Tuning Range: Intermediate Frequency: FM Mono Sensitivity: Seek lo sensitivity: Seek sensitivity Selectivity: Signal-to-Noise Ratio: Harmonic distortion at 1 kHz: Separation: Frequency Response: AM Tuning Range: Seek lo sensitivity Seek sensitivity: Intermediate Frequency: Signal-to-Noise Ratio: Frequency Response: 87. 5 - 107. 9 MHz 10. 7 MHz 13 dBf 51 dBf 31 dBf 80 dB at 400kHz 65 dB (stereo), 70 dB (mono) 0. 7% (stereo), 0. 5% (mono) 30 dB 30-15, 000 Hz ± 3 dB 530 - 1, 710 kHz 50 dBµV 25 dBµV 450 kHz 50 dB 30-5, 000 Hz + 3dB Audio Speaker Impedance: Maximum Amp Power: RMS Power: Bass Control: Treble Control: Loud: Preamp Output: 4-8 ohms 4 X 30 Watts (at 4 ohms) 4 X 13 Watts (at 4 ohms) <1% THD ± 10 dB @ 100 Hz ± 10 dB @ 10 kHz + 8 dB @ 60 Hz & + 2 dB @ 8 kHz 4-Channel, Low-Impendance (100 ) Preamplifier Over 3 Volts of Distortion-Free Preamp Output 90 dB 90 dB 5-20, 000 Hz + 3 dB . 01% 180 x 52 x 155 mm, 7 x 3 x 6 1/8 in. 1. 4 kg (3. 0 lb. ) 12 V DC car battery (11-16 V DC allowable) 15°F to 120°F, ­10°C to 50°C · Unit · Faceplate · Wire Harness, including 2-Channel RCA Preamp Output Harness · DIN Sleeve · Mounting Hardware · Owner's Manual in English, French, Spanish and Portuguese · 4-Channel Preamp Output Harness (Part No. 8634494218) (Available at 1-800-920-2121) CD Player Signal-to-Noise Ratio: Dynamic Range: Frequency Response: Harmonic Distortion: General Dimensions (w/o projecting parts/controls): Mass: Power Requirement (neg. grnd. ): Operating Temperature: Supplied Accessories: Optional Accessories: Design and specifications subject to change without notice. 11 Location of Controls 8 REL (Release) Button PWR (Power) Button Source (and Radio Band) Select Mute/Audio Button SCA (Scan) TS (Travel Store) LD (Loudness)/ SENS (Tuning Sensitivity) CLK/Display Change Disc Insertion Slot CD Eject + Button Volume + Bass + Treble + Balance Left Fade to Front 11. - Button Volume Bass Treble Balance Right Fade to Rear 1. [. . . ] 15 CD Track Cue and Review Press and hold /\ or V for audible cue or review. CD Track Repeat Play Press RPT to play current track repeatedly ("rpt" appears temporarily in display. ) (This cancels MIX or SCAN if previously active. ) If track manually advanced, RPT becomes active for new track. Mix Play Press MIX to randomly select a track and thereafter play tracks in random order ("rdm" appears temporarily in display. ) (This cancels RPT or SCAN, if previously active. ) A track will not be played a second time until all tracks have been played. CD Track Scan Press SCA to start Track Scan. [. . . ]