User manual BLAUPUNKT TP DX-V TITAN SKANDI

[. . . ] If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to contact the dealer or an experienced Radio/TV technician for help. You are cautioned that any changes or modifications not expressly approved in this manual could void your authority to operate this equipment. Owner's Record The model and warranty numbers are located on the top of the unit. Record the warranty (serial) number in the space provided below. Refer to these numbers whenever you call upon your Blaupunkt dealer regarding this product. [. . . ] · Don't assume that a seemingly matching wire harness in the vehicle has leads that match the leads of the unit's wire harness. · We recommend making and testing all electrical connections before installing the unit. Connect the leads (wires) according to instructions and diagram below. ELECTRICAL CONNECTION INSTRUCTIONS 1. Disconnect the vehicle battery's negative terminal before making connections. Connect the speakers and/or external amplifiers (if you have any) following the guidelines in the SPEAKER CONNECTION section below. Connect the blue (trigger output) lead to an amplifier's trigger input terminal and/or antenna motor trigger input terminal (if you have either or both of these items). The combined total amperage required for triggering the antenna motor and/or amplifier must not exceed 300 mA. DO NOT connect the blue lead to the antenna's and/or amplifier's power supply input. Connect the black (power ground) lead to a grounded metal part on the vehicle. We recommend grounding all audio system black ground leads (head unit, external amplifier, etc. ) to a common grounding point, preferably a non-painted surface under the instrument panel. Connect the yellow (constant power) input lead to a source of constant battery power, preferably a terminal to an appropriate slot in the fuse box. · · · · · ANTENNA MOTOR TRIGGER SWITCH * SWITCH * Harness has single blue lead that can be used for either antenna motor trigger or amp trigger or spliced for use with both. (See note 3. ) * 7 Installation Recommendations · Carefully choose the mounting location so that the unit won't interfere with normal driving. · Avoid mounting locations where the unit would be subject to high temperatures, such as from direct sunlight or hot air from the heater, or where it would subject to dust, dirt or excessive vibration. · The illustration below shows a typical installation, however, you may need to adjust the installation, depending on the unit. If you have questions or need additional installation hardware, consult your Blaupunkt dealer. · Make sure the unit is firmly anchored (preferably at both front and back) and does not vibrate . Mounting Hardware (1) Sleeve (2) Mounting Strap and Screw (3) Release Keys Mounting The Unit in Most Dashboards 1 Install the Sleeve (1) in the dashboard. 2 Select and bend the appropriate tabs to hold the sleeve firmly in place. 1. 4 kg (3. 0 lb. ) 12 V DC car battery (11-16 V DC allowable) 15°F to 120°F, ­10°C to 50°C · Unit · Faceplate · Wire Harness, including 2-Channel RCA Preamp Output Harness · DIN Sleeve · Mounting Hardware · Owner's Manual in English, French, Spanish and Portuguese · 4-Channel Preamp Output Harness (Part No. 8634494218) General Dimensions (w/o projecting parts/controls): Mass: Power Requirement (neg. grnd. ): Operating Temperature: Supplied Accessories: Optional Accessories: Design and specifications subject to change without notice. 11 Location of Controls 1. LD (Loudness)/ SENS (Tuning Sensitivity) 8. [. . . ] Cassette play will begin, and the display will indicate which tape program is in use, "1" or "2". · The tape will continue to play until ejected, SRC button pressed, or unit turned off. Ejecting The Tape Press the eject button completely towards the face of the unit. If uit is turned on, EJ will appear in the display for 2 seconds and the last-heard radio station will play. [. . . ]