User manual BLAUPUNKT TP DX-V TV GB

[. . . ] 8 Installation and safety notices . . . . . . . . . . 8 Positive connection . . . . . . . . . . . . . . . . . . . . . . . . . 8 Switching positive . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] 9 Negative (ground) connection . . . . . . . . . . 9 Specifications . . . . . . . . . . . . . . . . . . . . . . . . . . 9 Features . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 38 6 GENERAL INFORMATION Thank you for choosing a Blaupunkt product. We hope you enjoy using this new piece of equipment. Please read these operating instructions before using the equipment for the first time. The Blaupunkt editors are constantly working on making the operating instructions clearer and easier to understand. However, if you still have any questions on how to operate the device, please contact your dealer or the telephone hotline for your country. You will find the telephone number printed at the back of this booklet. The installation location should be such that the signal controller does not get in the way of the driver and cannot endanger the occupants in the event of the vehicle suddenly coming to a halt, for instance, during an emergency stop. Note: Before connecting the monitors to your signal controller, check that the +/- and switching positive connections are working properly. Signal controller 7 607 003 553 Connecting cable Screws Operating and installation instructions Positive connection Connect the fuse holder (1A fuse) to protect the positive cable (permanent (1), see Fig. The fuse holder should 8 INSTALLATION be connected to the positive terminal at a distance of max. 30 cm from the vehicle battery (if necessary, drill a hole in the bulkhead and use the appropriate cable grommets). SPECIFICATIONS Video input: Composite Video, 1. 0 Vpp, 75 Ohm RGB output (video signal, internal resistance 75 ohm): Typical 0. 7 Vpp RGB output (composite sync, internal resistance 75 ohm): Typical 1. 0 Vpp Power supply: DC12V, +/- 10%, max. 1A DEUTSCH Specifications Switching positive Connect the switching positive cable (2) (see Fig. 1) to the switching positive ) of the main deoutput (ignition vice (e. g. If connecting to terminal 15 of the vehicle, protect the switching positive cable (2) by installing a fuse holder (1A fuse) at a maximum distance of 20 cm from the point of connection. Negative (ground) connection Attach the negative cable (1) (earth/ GND, (3), see Fig. 1) directly to the vehicle body using a screw. Scratch the surface down to the bare metal at the point at which the earth contact is made and apply graphite grease (important for a good earth connection). [. . . ] 1) directly to the vehicle body using a screw. Scratch the surface down to the bare metal at the point at which the earth contact is made and apply graphite grease (important for a good earth connection). · If the installation requires holes to be drilled or any other changes to be made to the vehicle, please contact a specialist workshop in your area. [. . . ]