User manual BLAUPUNKT TP E EXACT MP3 GR/GR IBE

[. . . ] Our warranty shall be vain if the connection is made inadequately. To prevent inadequate electrical connection in vehicles equipped with ISO connectors, use the universal ISO adapter cable (P/N 7 607 621 126) for constant power connection, negative connection, the positive connection via the ignition, illumination and +12V switching output for external components such as a power antenna. At present, the following vehicles with standard ISO connectors can be adapted using the universal ISO adapter cable: Alfa Romeo, Citroen, Fiat, Honda, Lancia, Mercedes, Peugeot, Porsche, Renault, Skoda. For all other car models with standard ISO connector use the car-specific adapter cable. [. . . ] Car radio, loudspeakers with amplifier (active) or without amplifier (passive), antenna with or without amplifier, power antenna, window antenna. What adapters are used for the existing car radio?Are there standard ISO connectors (which are compatible with your Helsinki car radio) or car specific adapters? what cross-section do the existing cables have?Vehicles without car radio Are loudspeakers and power cables installed in your car?What does an standard ISO connector look like?Take a look at the cables included in the delivery. Both cables are equipped with standard ISO connectors. The two red wires and the brown wire of the positive and negative cable have a cross-section of 1. The pinning of standard ISO connectors may differ according to auto manufacturer. While installing and mounting this equipment, you must disconnect the negative terminal of the battery. For the most common cars with deviating installation places Blaupunkt offers specific 50-mm car radio installation kits. Therefore, please check the car radio installation place in your car. If required, use one of our car-specific installation kits. If your vehicle is equipped with a specific car radio mounting sleeve (e. Steering wheel remote controls installed in some vehicles can be adapted by means of an interface. Contact your specialist dealer for more information. The mounting sleeve included with this car radio is designed for installation in vehicles with standard DIN installation compartment measuring 182 x 53 mm, 165 mm installation depth and a dashboard thickness of 1 to 20 mm in the area of the tab fasteners (see Fig. Insert the car radio into the sleeve and check which tabs on the sleeve can be bent with the help of a screwdriver (see Fig. Insert all connectors into the chambers until the side catches engage. Place the car radio in the front of the sleeve and push it in gently on both ends of the sleeve until the left and right side springs snap into place (you will hear an audible click), see Fig. Do not push on the display, keys or switches! [. . . ] Lay the positive cable (red) with large cross-section (min. 5 mm2) to the battery (do not route any cable close to a wire harness). Connect the ground cable to a suitable ground spot (car body screw, car body sheet). Strip off the insulation at the end of the ground cable and attach a spade lug (resolder if necessary). [. . . ]