User manual BLAUPUNKT TP E EXACT R/BL BENE

[. . . ] U For this reason, listen to your car sound system at a suitable volume level during your journey. The scope of delivery contains a 3-pole and 6-pole Molex plug with connector pins, an IR receiver with 4-pole Molex plug, an IR remote control and two 1. Power supply Create a cable for the power supply of the TV tuner. Feed a cable from Pin3 (ON) to the VIDEO RELAY socket at your CCA or CPA (switched power supply of the video monitors). [. . . ] Feed a cable from Pin3 (ON) to the VIDEO RELAY socket at your CCA or CPA (switched power supply of the video monitors). Connect Pin2 with an earth wire and Pin1 with a +12-V or +24-V line. Under the surface on which the device is to be installed, there may not be any wires or tubing. do not install the device in a place , · Where it is subject to direct sunlight, · Where it is subject to rain or moisture, · Where it is subject to dust or dirt, · Where it is subject to strong vibrations. IR remote control The infrared receiver of the remote control can be connected to the 4-pole IR-REMOTE socket D and installed anywhere in the vehicle. Audio/video To integrate the TV tuner into your existing Classic Line system, you need 2 audio cables (7 607 402 000) and 2 video cables (7 607 263 001). Of the TV tuner and with the first monitor in your Classic Line system. Cable remote control and source selection To be able to operate the TV tuner with the CCA, you must install the following cables: Cable set (7 607 006 418 / 419) · Connect Pin1 of chamber A of your CCA with the video remote connection of the jack socket. Connect Pin2 of chamber A of your CCA with the earth connection of the jack socket. Audio/cable remote control To integrate the TV tuner into your existing Professional Line system, you need the video remote cable (7 607 006 437). For this purpose, you must set the TV tuner to the video device. Source switching with the CCA If the TV tuner is installed in a Classic Line system, u press the VIDEO button on the CCA to view the TV/video image on the monitors. To switch the sources with the CCA, u press the CAM button on the CCA repeatedly until either the TV image or the image of the video device is displayed. Source switching with the CCU If the TV tuner is installed in a Professional Line system, u press one of the VIDEO buttons on the CCU repeatedly until the TV or the video image is displayed on the monitors. To listen to stations (channels) stored with Travelstore or manually, u press the PROG CH , button 2 or the number buttons < corresponding to the program location. U If necessary, adjust the image for perfect image quality using the SEARCH CH , buttons 3. You can operate the following basic functions of the TV tuner with the CCA or CCU. Function Next memory location Previous memory location Seek tuning forwards Seek tuning down Function Next memory location Previous memory location Seek tuning forwards Seek tuning back CCA To avoid voltage peaks while changing the source, you can adjust the volume differences between the TV tuner and the video playback device. To switch between TV and AV, u press the corresponding number button 1 or 2 <. (EU countries only) Do not dispose of your old device in the household trash! [. . . ] To switch between TV and AV, u press the corresponding number button 1 or 2 <. (EU countries only) Do not dispose of your old device in the household trash!Please use the return and collection systems available to dispose of the old unit. 3 V Video ­ dependent upon audio input level (Ri < 300 ohm), stereo Video input level: 1 Vss (Cinch, Ri= 75 ohm) Audio input level: max. [. . . ]