User manual BLAUPUNKT TP E EXACT R/W BENEL

[. . . ] The positive cable must have a cross-section of at least 2, 5 mm2. Attention: Pay attention that the cables do not contact with the housing. Note: By means of the support included in the delivery you can mount the set in cars with a DIN car radio cut-outout of 182 x 53 mm, an installation depth of 165 mm and an instrument panel thickness around the fixing clips of 1 - 20 mm, see fig. [. . . ] Note: By means of the support included in the delivery you can mount the set in cars with a DIN car radio cut-outout of 182 x 53 mm, an installation depth of 165 mm and an instrument panel thickness around the fixing clips of 1 - 20 mm, see fig. For cars with other cut-out dimensions Blaupunkt delivers car-specific installation kits for common car types for 50/52 mm sets. Please check the dimensions and, if necessary, use a car-specific installation kit, e. When using installation sets for units of 52 mm four distance plates, order number 8 601 055 056, must be used, fig. Insert the car radio from the front into the support and push in until the stop springs on the sides engage right and left (distinct click to be heard). Insert the brackets right and left into the provided trimplate holes and push in until you hear a distinct click (lateral springs are unlocked). Note Locked brackets can only be removed after taking out the unit. If these notes are disregarded, there is danger of destroying the final stages. do not connect speaker outputs to ground!Connection with multiple plug installed ex factory When connecting a fully automatic motor antenna, use the cable clamp to fasten the control cable of the motor antenna to the control cable. lighting connection (Illumination) Lighting connection for vehicles with adjustable dashboard lighting (pluscontrolled). Telephone mute (Low) If you have connected a car telephone, your car radio will be mutet during telephone calls. Connecton with vehicle specific Quick-Fit Not possible Note: Do not use the 2-channel Audi QuickFit 7 607 867 090. Connection with QuickOut installed ex factory If your car is fitted with a QuickOut ex factory (at present Opel), the QuickOut ex factory has to be removed. [. . . ] Connecton with vehicle specific Quick-Fit Not possible Note: Do not use the 2-channel Audi QuickFit 7 607 867 090. Connection with QuickOut installed ex factory If your car is fitted with a QuickOut ex factory (at present Opel), the QuickOut ex factory has to be removed. Stick in byglar till vänster och till höger i de befintliga hålen i panelen och tryck in så långt, att ett tydligt knäpp hörs (sidofjädrarna går ur ingrepp). [. . . ]