User manual BLAUPUNKT TP E EXACT R/W SK

[. . . ] 4 Position of the Built-in Anti-Vibration Armature . . . . . . . . . . . . . . . . . . . . 5 Using the Changer . . . . . . . . . . . . . . . . . . . 6 Loading a CD . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 Installing the Magazine . . . . . . . . . . . . . . . . . . . . [. . . ] This device is equipped with a built-in automatic protection circuit. If the temperature reaches a pre-set value, the automatic protection circuit will shut down the entire device. If this happens, open a window and let the car cool down. ENGLISH PORTUGUÊS ESPAÑOL FRANÇAIS Safety Instructions Tips for Safe Operation Condensation On rainy, damp days or just after turning on the car heater, water vapour may condense on the laser lens of the CD changer. If this happens, the equipment will not function properly. To counteract this, remove the magazine from the device and wait for approximately one hour. During this time, the water vapour will evaporate, after which the equipment will function normally again. Remove the magazine from the CD changer at temperatures above 60° C if it is not in use, or before long periods of disuse at any temperature. 3 BEFORE INSTALLING THE EQUIPMENT Before Installing the Equipment Transport Locking Screws The mechanism in the CD changer is "locked" by the transport screws during shipping. Make certain to remove these screws before installing the changer. Precautions for Installation and Wiring 1. Do not install the equipment in the following locations: - Locations that are exposed to direct sunlight. - Locations at which warm air exits the car heating system. - Locations in which proper installation is impossible and locations in which many vibrations are produced. Note: After removing the transport locking screws, place the enclosed seals over the screw holes. - The changer changes to the next CD before it has finished playing the first CD. - The changer plays the same CD over and over again. - The system will not play a specific CD. Bur things happen, use a pen or a similar object to remove the burs as shown in the figure at right. Note: Although there are protective films marketed as CD accessories, use of these products leads to malfunctions and should be strictly avoided. Dirt, dust, scratches, and deformations cause skipping and diminished sound quality during playback. Here are some tips on how to take care of your CDs: 1. Use CDs that bear the following symbol. Bur Centre hole Outer circumference Remove from the CD surface all plastic particles from burs before inserting the CD in the magazine. These symptoms occur when there are burs on the CD in the centre hole or along the outer circumference of the CD and, as a result, the CD is not drawn into the changer properly or sticks somewhat inside the magazine. Use a soft cloth to wipe away fingerprints and dust from the playable (shiny) side of the CD. Unlike phonograph records, CDs have no grooves to collect dust and small particles. Thus gentle wiping is usually sufficient to remove most particles. [. . . ] Do this using the hex bolts (M6 x 12) and hex nuts (M6). 5. - Using the hex bolts again, refasten the changer on top of the carpet. Position of the built-in antivibration armature Hex bolts (M6x12) Hex bolts (M4x5) 12 INSTALLATION - Lift up the carpet and decide where you want to mount the unit. - Fasten the double-stick tape supplied to the bottoms of the brackets (B) and remove the protective backing from the tape. - Fasten the unit to the floor by pressing it down firmly. - Using a knife, cut through the carpet directly above the bolts of the mounting bracket (B). [. . . ]