User manual BLAUPUNKT TP E2 W/R IBERIA

[. . . ] Our Velocity Amplifiers are fitted with all typical product features expected from a high-end amplifier, but also contain a number of technical highlights as well, such as: · Transistors for power supply using MOSPET technology · Gold-plated screw connectors for loudspeaker and power supply · Bass-Boost To achieve the best possible sound quality from your new Velocity Amplifier we recommend that it is installed by an authorised Velocity dealer and that the matching Velocity Loudspeaker system is used. This is the way to obtain the full enjoyment of the performance of your amplifier. Let us finally mention the aspect of health safety. Please remember when listening to music in your car that constant sound-pressure levels of more than 100 dB can cause permanent damage to the human ear right up to complete loss of hearing. [. . . ] Sound-pressure levels of more than 130 dB can be achieved with modern high-performance systems and highquality loudspeaker configurations. Tri-Mode Allows you to drive two loudspeakers and to connect a third speaker in mono operation (bridged mode) , Fig. Lay commercially available positive cable to the battery and connect using fuse holder. The fuse holder should be connected close to the battery. use cable bushings at sharp-edged holes. Screw the commercially available negative cable firmly to an interference-free earthing-point (car body bolt, car body sheet, but not to the negative battery pole). Scrape the contact surface of the earthing point until it is blank metal and coat with graphite grease. +12V Controller (GAIN) Using the Gain Controller you can adjust the input sensitivity of the Velocity Power Amplifier to the output voltage of your car radio preamplifier output. When connecting a car radio from other manufacturers the input sensitivity should be adapted in accordance with the specifications of the You can also obtain further information on our Velocity Series at our Internet address http://www. The specifications of the loudspeakers used must be taken into account without fail when carrying out the fine adjustment of the frequency divider. Crossover frequency controller (LP + HP) If the frequency divider (low-pass or high-pass) has been activated using the crossover switch, then it is possible to adjust the crossover frequency of the relative filter between 40 Hz and 250 Hz / 40 Hz and 120 Hz in infinitely variable stages. This controller has no function when the unit is set to Full Range mode. Bass Boost You can adjust the bass output of the Velocity amplifier using the bass boost control. the settings range covers 0 dB to +18 dB. Subsonic Filter The subsonic filter can be used when a subwoofer is connected to the amplifier. It can be activated in order to protect the subwoofer against mechanical overload due to bass frequencies that fall outside our hearing range. input MODE 4 CH: To operate the Velocity amplifier in 4-channel mode (stereo front / rear). In this case, all 4 inputs must be connected to the source device (car radio). [. . . ] input MODE 4 CH: To operate the Velocity amplifier in 4-channel mode (stereo front / rear). In this case, all 4 inputs must be connected to the source device (car radio). 2 CH: To operate the Velocity amplifier in 4-channel mode (stereo) with 2 input signals. The usual Ycable is not needed with this configuration. [. . . ]