User manual BLAUPUNKT TRAVEL PILOT 200 FRANCE

[. . . ] · While you are driving, only use the voice output and directional symbols on the monitor. · Stop your vehicle at a suitable location if you wish to re-program the TravelPilot RGS 06 or look up more detailed information. Route guidance The current traffic routing situation can differ from the data stored on the CD-ROM. Due to system limitations, the TravelPilot RGS 06 cannot warn of altered traffic routing conditions e. g. If you do not pay attention to the actual traffic routing conditions, there is a danger that you will cause a serious accident. [. . . ] Note: If the destination you entered is not included in the digitised network of streets (e. g. special destinations such as workshops, etc. ), an arrow will appear in the display, as soon as you leave the digitised area, indicating the direction in which your destination lies. The voice output announcement for this is: "You have reached the area of your destination". If you are in the immediate vicinity of your destination, the voice output announcement will inform you that: "You have reached your destination". a stored location) is not situated within the digitised area, you will hear the announcement: "No route guidance is available to your destination". The display will then show No route and the arrow will point in the direction in which the destination lies. 17 Traffic congestion Using the "Traffic congestion" function, the calculated route can be altered according to the current traffic situation. This means that if you see a problem with the traffic up ahead or you are informed about this over the radio (e. g. a traffic jam or road works), you can exclude certain route sections starting from your current vehicle position. The route sections that can be excluded refer to the road network that lies ahead of you and your vehicle. Each section comprises the section of road located between two road junctions. a bar graph representing the distance up to the next recommended turning (to the right next to the driving recommendation symbol) 20 Map display If the navigation symbol display has been activated, you can switch to the map display by pressing the key. The map will be shown orientated in the direction of travel when using map scales of up 20 km. At a scale greater than 20 km, the map will be displayed orientated in the direction in which your destination lies, and at a scale greater than 100 km the map will be shown orientated in a northerly direction. The scale can be adjusted by pressing the / keys. The map display shows: the route that has been calculated (flashing). and, depending on the map scale, the the current vehicle position destination as well. the name of the street currently being driven down (at the bottom). the actual distance left to drive to your destination (above left) or the name of the street into which you are supposed to turn. an info bar (left) containing the time to travel, route recommendation, compass, GPS status and the direction in which the destination lies. This info bar can be switched on or off by pressing the key. a colour street map with a light grey basic background colour and including railway lines, rivers and special map symbols. [. . . ] Next, select Set location and press the ENT key. 40 5. Now enter a destination in the usual manner and start route guidance. After the route has been calculated, the demo will run automatically. While in demo mode, all functions can be operated as if the unit were operating under real conditions. [. . . ]