User manual BLAUPUNKT TRAVELPILOT 500

[. . . ] www. blaupunkt. com Mobile Navigation TravelPilot 500 Operating and installation instructions (Long version) Device overview Device overview 1 2 3 4 6 7 5 8 9 10 11 12 17 16 15 14 13 2 Device overview 1 Display (touchscreen): Simple and intuitive operation by touching the buttons on the display. 2 VOL -: Decreases the volume 3 On/Off switch: · Long press (for longer than 1 second): Switches the device on · Long press (for longer than 3 seconds): Switches the device off · Short press: Calls up the main menu 4 VOL +: Increases the volume 5 Socket for additional external TMC antenna (internal TMC antenna is present) 6 Memory card slot 7 Socket for power supply (battery charger or charger cable for the cigarette lighter) 8 Stylus for operation on the display 9 Digital camera, among other things for recognising signs : Light sensor for automatic display brightness (top side) ; Socket for additional external GPS antenna (internal GPS antenna is present) < Battery compartment cover = Microphone for speech input and hands-free system (Bluetooth) > Socket for headphones ?· Do not modify or open the device. Otherwise, it could be damaged and then ignite or explode. [. . . ] If you register an eleventh one, the oldest cell phone is deleted. · The Bluetooth connection can be established only to one cell phone. If additional ones are available, only the cell phone registered last is connected. The search for Bluetooth-ready devices starts. u Proceed as described in the chapter "Registering with the navigation device" and enter the PIN "0000". 42 Bluetooth function Switching visibility on/off For the Bluetooth connection, the navigation device must be visible to other Bluetooth-ready devices. Touch the symbol to switch the visiu bility on (check mark) or off (no check mark). Paired devices All registered cell phones are listed in the Paired Devices menu and can be edited. Prerequisite: · Bluetooth function and visibility in the cell phone are activated Note: The Bluetooth connection can be established only to one cell phone. If additional ones are available, only the cell phone registered last is connected. Touch the symbol to establish the Bluetooth connection. Touch the symbol to disconnect the Bluetooth connection. Touch the symbol to rename the cell phone in the list. Touch the symbol to delete the cell phone from the list. Touch the symbol to delete all cell phones. Ringtone u Touch the symbol. u Press the VOL - or VOL + button to adjust the volume. Establishing the connection automatically If you switch off the device, the Bluetooth connection is disconnected. The automatic connection causes the devices to be reconnected as soon as the device is switched on again. On the second page of the Bluetooth u Settings menu, touch the symbol to allow the automatic connection (check mark) or to prevent it (no check mark). Changing the PIN If you want to connect devices with each other via Bluetooth, you are requested to enter a PIN. By default, this PIN is "0000", but it can be changed. u The Change PIN Code menu is displayed. u Enter a new PIN of your choice via the keyboard. RAS settings Access to the Internet with the navigation device (ch. [. . . ] "Working with the map", "Map/navigation settings") · How to activate and deactivate POI notes to be notified about your POIs in time (ch. "Working with the map", "Map/navigation settings") · How to load your planned tours from a memory card (ch. "Tour planning") · How to select your planned tour from the memory (ch. "Using a destination/tour from the destination/tour memory") 17 Country: Germany Austria Denmark Finland Great Britain Greece Ireland Italy Luxembourg Norway Portugal Spain Sweden Switzerland Czech. [. . . ]