User manual BLAUPUNKT TRAVEL PILOT E1 WEISS GG

[. . . ] Electrical connection 1. 1 Electrical connection to the vehicle-specific plugs If your car radio connection in your vehicle has already been fitted at the factory with 10 A fuse protection (see operating instructions or your vehicle's fuse box), you will additionally need the vehicle-specific adapter cable (see Fig. A vehicle-specific adapter cable must also be used even in vehicles that are already fitted with ISO plugs. Notices on correct functioning To ensure the navigation system functions correctly, it is very important that you calibrate it after installation (see operating instructions / Setup - Basic settings / Installation). The system uses its connection with the vehicle's speedometer signal to determine the distance driven along the route. [. . . ] TravelPilot installation The TravelPilot is installed in the car radio compartment designated by the vehicle manufacturer. For vehicles that do not have a DIN compartment: Blaupunkt supplies vehicle-specific installation kits (for 50/52 mm devices) for the most common vehicle models. Therefore, please 4. 2 Installing the TravelPilot in the installation compartment All plugs must be pushed into the chambers until the side clips click into place. Before inserting the TravelPilot completely, you must first level out the gyro (see Fig. TravelPilot installation position: right / left: min. +30°. Slide the device 1/3 of its length into the installation compartment. Use the hexagonal wrench to adjust the position of the gyroscope so that the marker is in a vertical position and forms a 90° angle with the horizontal. Now, by gently pressing on both ends of the frame, push the TravelPilot in until the side spring latches on the left and right lock into place (you will hear a clear clicking sound). When pushing in the device, do not press on the display or any of the buttons or switches! Note: The clipped in stirrups can only be detached after the TravelPilot has been pulled out. Caution!We do not accept liability for incorrect connections and their consequences. 4. 4 Connecting the reversing light signal Lay a cable from the reversing light to pin 3 of chamber A (see Fig. You must make sure that +12 V are present at the connection when the vehicle reverses. Note: If it is not possible to connect to the reversing light, you must connect pin 3 to earth. This might lead to navigation inaccuracy since the TravelPilot will not be able to detect whether the vehicle is reversing. We do not accept liability for incorrect connections and their consequences. 5. Sensor test After carrying out the installation, you should test the connected sensors using the sensor test (see operating instructions / Setup - Basic settings / Installation). 6. Connection diagrams Electrical connection to the vehicle-specific plugs . . . . . . . . . . . . . . . . . [. . . ] Lay the ground cable to a suitable earth connection point (e. g. a bolt connected to the car body / sheet metal of the car body) and screw it in place. Illumination connection Illumination connection for vehicles with an adjustable instrument illumination (regulated positive). [. . . ]