User manual BLAUPUNKT TRAVEL PILOT RGS 06

[. . . ] TravelPilot RGS 06/08 5" TFT Display 7 612 001 126 Installation notes for authorired service workshopsInstructions de montage pour atelier service après-vente agréé -1- Table of contents Safety information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Installation and connection regulations . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Product information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Notes on the operation of the equipment . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] If necessary, use protective sheathing to protect the antenna cable from being pinched. The adherent surface of the antenna must be free of dirt, snow, ice, etc. You must not lengthen, shorten or put a kink in the antenna cable. Do not remove the plug during the installation. If the antenna is painted the same colour as the vehicle, this may have an adverse effect on the reception, especially if paints containing a high percentage of metal are used. We assume no guarantee that the antenna will operate properly after it has been painted. On notchback vehicles, attach the antenna to the boot lid using the mounting brackets. Depending on the thickness of the metal, use the corresponding headless screws, Fig. On estate and hatchback cars, affix the antenna to the roof with its magnetic foot, Fig. For a roof mount, remove the mounting brackets. Use the adhesive strips enclosed to cover the screw holes, Fig. For estate and hatchback cars, lay the antenna cable along the rain gutter downwards and into the interior of the vehicle. Any obstacles near the antenna, such as roof racks or bicycle carriers, may have an adverse effect on or even obstruct satellite reception. Route the antenna cable into the interior of the vehicle and connect the plug on the antenna cable with the antenna jack on the basic unit. It is advisable to remove the antenna from the roof when driving through a car wash. If the GPS antenna is mounted inside the vehicle, there is no guarantee that the system will function correctly. Fig. 7 The display is mounted directly on a console (telephone console) with the ball joint. 8 The display is mounted using the gooseneck 7 612 001 204 and the ball joint. It is necessary to remove the back panel of the display first. Drill a 10-mm hole at the mounting location to accommodate the wiring and lay the wiring without subjecting it to any tensile strains or other loads. 9 1 Unscrew the four screws on the back of the display and remove the rear panel. 2 Pull out the plugs carefully and push them through the mounting base. [. . . ] For left-hand drive vehicles, mount the wheel sensor and the magnetic strip on the non-driven left-hand wheel, for right-hand drive vehicles, on the non-driven right-hand wheel. For four-wheel drive cars, on the lefthand rear wheel. In order to mount the wheel sensor and the magnetic strip, the vehicle must be jacked up. Always observe the safety instructions provided by the automotive trade! [. . . ]