User manual BLAUPUNKT TV TUNER

[. . . ] The warranty terms can be called up under www. U Only operate this device if the road and traffic conditions allow you to do so. U Familiarise yourself with the device before setting off on your journey. [. . . ] To be able to remotely control the video source as usual with the CCA or CCU, you must use the video remote cable (7 607 006 437) for the connection. Connect the video cable with the video output of the playback device and with the A/V Input ­ Video input F of the TV tuner. When you operate the TV tuner for the first time, you must insert the batteries in the remote control. Operating angle: Approximately 30° in each direction from the front of the remote control. Operating the TV tuner with Tuning into a station There are different ways of tuning into a the IR remote control If you operate the TV tuner without the Coach system (Stand-alone), u you switch it on and off with the POWER button 1 of the remote control. The TV tuner is equipped with an OSD menu (On-Screen Display) which displays different setting functions on the monitor. Station seek tuning For a channel seek tuning to the next receivable station up or down in the band, u press the SEARCH CH or button 3. The seek tuning starts and stops at the next receivable station. Travelstore seek tuning With terrestrial reception, you can store up to 70 stations and with cable reception up to 56 stations. After the entire band has been scanned, the Travelstore seek tuning stops at the first stored station. You can adjust whether the TV tuner should receive a terrestrial program via antenna or whether it is connected to a TV cable network. To switch between the functions, u press the corresponding number button 1 or 2 < on the remote control. To call up the station saved last with MEM, u press the RECALL button 4. you can assign a desired program location to the set station. [. . . ] Via det här uttaget leds ljudsignalerna från videokällan till TV-mottagaren och signalerna från fjärrkontrollen till videokällan. Dra en kabel från stift 3 (ON) till uttaget VIDEO RELAIS på CCA- eller CPA-enheten (ansluten strömförsörjning till videomonitorn). Koppla stift 2 till jord och stift 1 till en +12-volts- eller +24-voltsledning. [. . . ]