User manual BLUE SKY PRODESK SUB 8 ACTIVE SUBWOOFER

[. . . ] Owner's Manual for 2. 1 (Stereo) Application ProDeskTM SAT 5 Active Satellite SUB 8 Active Subwoofer blue sky ProDeskTM SAT 5 Active Satellite & SUB 8 Active Subwoofer Owners Manual for 2. 1 (Stereo) Applications Issue 1, rev 4 Contents 1. Safety Instructions _ __ __ __ __ __ __ __ __ __ __ __ _ 3 Philosophy & Introduction _ __ __ __ __ __ __ __ __ _ 4 Important notes about ProDeskTM and this Owner's Manual _ __ __ __ __ __ __ __ __ __ _ 4 Quick Setup _ __ __ __ __ __ __ __ __ __ __ __ __ __ _ 5 System Signal Connection Diagram _ __ __ __ __ __ _ 6 A Tour of SAT 5 _ __ __ __ __ __ __ __ __ __ __ __ __ _ 7 A Tour of SUB 8 _ __ __ __ __ __ __ __ __ __ __ __ __ _ 8 Expanded Setup Guide _ __ __ __ __ __ __ __ __ _ 10 Cable and Wiring Specifications _ __ __ __ __ __ _ 11 Technical Information _ __ __ __ __ __ __ __ __ __ _ 12 Satellite Cabinet Dimensions _ __ __ __ __ __ __ _ 13 Subwoofer Cabinet Dimensions _ __ __ __ __ __ _ 14 The Functional Volume Control * _ __ __ __ __ __ _ 15 Factory Service Instructions _ __ __ __ __ __ __ __ _ 16 General Contact Details _ __ __ __ __ __ __ __ __ _ 16 * The FVC is an optional upgrade and is not included with ProDeskTM Contents blue sky ProDeskTM SAT 5 Active Satellite & SUB 8 Active Subwoofer Owners Manual for 2. 1 (Stereo) Applications Issue 1, rev 4 Safety Instructions 1 READ INSTRUCTIONS - Read all safety and operating instructions before operating this product. RETAIN INSTRUCTIONS - Retain these safety and operating instructions for future reference. 11. 2. SERVICING - Do not attempt to service this product yourself. Opening or removing covers, including any over bottom or side speaker drivers, may expose you to dangerous voltage or other hazards. [. . . ] Do not connect more than one source to this input. Refer to the wiring table below for wiring custom cables and connectors. Do not connect more than one source to these inputs. Refer to the wiring table below for wiring custom cables and connectors. 10. 1/4 X 20 INSERTS - Located on the bottom of the subwoofer cabinet are four 1/4 X 20 inserts for spiked or rubber feet. 2. RIGHT/LEFT OUT - This XLR output should be connected to the right/ left input of the active satellite speaker. The outputs are electronically balanced. These outputs are not bandwidth limited and are designed to be used with the SAT 5 or other monitor that has an 80Hz internal high pass filter network. Refer to the wiring table in bullet point 1 for wiring custom cables and connectors. SUB IN - This XLR input should be connected to either the subwoofer output of an external bass-management controller or the daisy-chain output (SUB OUT) of another Blue Sky Active Subwoofer. This input is fullbandwidth (up to approximately 200Hz) and does not use a low pass filter. Refer to the wiring table in bullet point 1 for wiring custom cables and connectors. SUB OUT - A Subwoofer output for connecting additional subwoofers. This should be connected to the SUB IN of an additional Blue Sky SUB 8. SUB GAIN CONTROL & POWER LED - This knob controls the input sensitivity of the subwoofer amplifier only. When set to the reference position, a 100mv signal at the input equals 90dB of output at one meter. Next to the knob is the power indicator LED. FUNCTIONAL VOLUME CONTROL (FVC) RJ-11 Connector Jack - This standard six conductor RJ-11 jack is used to connect the subwoofer to the optional FVC. The remote control cable length should not exceed 100 Feet. For more information on the FVC, please turn to page 15 "The Functional Volume Control". POWER SWITCH - This switch controls the power to the subwoofer amplifier and all internal electronics. FUSE - 2. 0 Amp Slow Blow Fuse - Replace with same rating and type. This fuse is for 120 VAC / 60Hz operation only. For products purchased in countries outside North America, please see the FUSE and POWER addendum included with this product. [. . . ] The FVC is now operating normally 3. Page 15 blue sky ProDeskTM SAT 5 Active Satellite & SUB 8 Active Subwoofer Owners Manual for 2. 1 (Stereo) Applications Issue 1, rev 4 13. Factory Service Instructions Service for the U. S. versions of Blue Sky products is available only from our authorized distributor, Group One Ltd. , located in Farmingdale, New York. (Service for Blue Sky products outside the United States can be obtained through local dealers or distributors. ) If your monitor needs service, follow these instructions: 1. [. . . ]