User manual BLUE SKY SAT 6.5 ACTIVE SATELLITE

[. . . ] SAT 6. 5 Active Satellite SUB 12 Active Subwoofer Owner's Manual for 2. 1 (stereo) Application blue sky SAT 6. 5 Active Satellite & SUB 12 Active Subwoofer Owners Manual for 2. 1 (stereo) Applications Issue 1 Contents Important 1 2 3 4 5 6 7 8 9 10 11 12 13 Safety Instructions _ __ __ __ __ __ __ __ __ __ _ Page 3 Philosophy and Introduction _ __ __ __ __ __ _ Page 4 What is THXpm3® Certification_ __ __ __ __ __ _ Page 4 Quick Setup _ __ __ __ __ __ __ __ __ __ __ __ _ Page 5 System Signal Connection Diagram _ __ __ __ _ Page 6 A Tour of Sat 6. 5 _ __ __ __ __ __ __ __ __ __ _ Page 7 A Tour of Sub 12 _ __ __ __ __ __ __ __ __ __ _ Page 8 Expanded Setup Guide _ __ __ __ __ __ __ __ _ Page 10 Cable and Wiring Specifications _ __ __ __ __ _ Page 11 Technical Information _ __ __ __ __ __ __ __ __ _ Page 12 Satellite Cabinet Dimensions _ __ __ __ __ __ _ Page 13 Subwoofer Cabinet Dimensions _ __ __ __ __ _ Page 14 Factory Service Instructions _ __ __ __ __ __ __ _ Page 15 Contact Details _ __ __ __ __ __ __ __ __ __ __ _ Page 15 Contents blue sky SAT 6. 5 Active Satellite & SUB 12 Active Subwoofer Owners Manual for 2. 1 (stereo) Applications Issue 1 Safety Instructions 1 READ INSTRUCTIONS - Read all safety and operating instructions before operating this product. 11. SERVICING - Do not attempt to service this product yourself. Opening or removing covers, including any over bottom or side speaker drivers, may expose you to dangerous voltage or other hazards. Refer all service to qualified service personnel. 2. RETAIN INSTRUCTIONS - Retain these safety and operating instructions for future reference. HEED WARNINGS - Follow all warnings on this product and in the operating instructions. [. . . ] Just remember - Use your ears, they are the best audio tool you have and you will be amazed how accurate the setup can be if you use familiar audio material during the setup of the system. You have now completed the set up of one of the world's finest monitoring systems. If you have any questions, please do not hesitate to contact us directly with your questions. Do not connect more than one source to these inputs. Refer to the wiring table below for wiring custom cables and connectors. 1/4 X 20 INSERTS - Located on the bottom of the subwoofer cabinet are four 1/4 X 20 inserts for spiked or rubber feet. IEC POWER TERMINAL - Connect to 120 Volt AC / 60Hz power source, rated for 430 WATTS. Use the included IEC Power Cable. 2. RIGHT/LEFT OUT - This XLR output should be connected to the right/ left input of the active satellite speaker. The outputs are electronically balanced. These outputs are bass-managed and are therefore bandwidth limited to spectral content above 80Hz. Refer to the wiring table in bullet point 1 for wiring custom cables and connectors. 3. SUB IN - This XLR input should be connected to either the subwoofer output of an external bass-management controller or the daisy-chain output (SUB OUT) of another Blue Sky Active Subwoofer. This input is fullbandwidth (up to approximately 200Hz) and does not use a low pass filter. Refer to the wiring table in bullet point 1 for wiring custom cables and connectors. 4. SUB OUT - A Subwoofer output for connecting additional subwoofers. This should be connected to the SUB IN of an additional Blue Sky SUB12. 5. MUTE - This switch is used to activate the automatic mute circuit built into the subwoofer. When the automatic mute circuit is activated, the system will automatically mute both the subwoofer and satellite outputs when no signal is present for 15 minutes. Once signal is present again, the system will automatically turn on. 6. PHASE - This switch is used to change the phase response of the subwoofer only. When this switch is in the 0 position, it is in-phase with the signal going to the Active Satellites. When this switch is in the position marked 180, it is 180 degrees out-of-phase with the signal going to the Active Satellites. Please refer to the Expanded Setup Guide (page 10) for instructions on how to use this switch. SUB GAIN & Power LED - This knob controls the input sensitivity of the subwoofer amplifier only. When set to the reference position, a 100mv signal at the input equals 90dB of output at one meter. Next to the knob is the power indicator LED. [. . . ] Subwoofer Cabinet Dimensions Page 14 blue sky SAT 6. 5 Active Satellite & SUB 12 Active Subwoofer Owners Manual for 2. 1 (stereo) Applications Issue 1 12. Factory Service Instructions Service for the U. S. versions of Blue Sky products is available only from our authorized distributor, Group One Ltd. , located in Farmingdale, New York. (Service for Blue Sky products outside the United States can be obtained through local dealers or distributors. ) If your monitor needs service, follow these instructions: 1. [. . . ]