User manual BLUEANT V1

[. . . ] The revolutionary BlueAnt V1 voice controlled portable headset marks the future of voice controlled Bluetooth devices. Its voice activated `prompt and response' interface combined with the BlueAnt Voice Isolation TechnologyTM software, provide the BlueAnt V1 with high quality and easy to use voice communications. Its dual microphones provide clear and clean voice input enabling superb Noise Suppression, Echo Cancellation and Wind Noise Reduction. The V1 can store information and wirelessly interact with up to eight different Bluetooth compliant devices (backward and forward compatible), including mobile phones, PDA's, PC's / Mac's or any Bluetooth enabled device that supports Headset profile or Handsfree profile. [. . . ] The V1 can store pairing information for up to 8 different Bluetooth devices. To pair another phone, make sure the first paired phone has Bluetooth switched off or is out of range. If you want to connect to a previously paired phone, use that phones Bluetooth Menu to connect. Note: You can say `Pair Me' to enter pair mode at any time, or follow the steps below 14 (This is an example only and may differ from your phone, but the process will be the same. First turn the phone OFF and then back ON again to refresh its memory. Bring the mobile phone to about 30cm from the V1 Device. (Check your mobile phone user guide if necessary) 4. With the V1 OFF, Press and Hold the BAB for about 6 seconds. the LED will appear a solid Blue , and then will start flashing. The V1 is now in Pairing mode and ready to be found in searches by other Bluetooth devices. Perform a Bluetooth device discovery on your mobile phone to add a new device. (It takes a few seconds to search for and find other Bluetooth devices around you). When Bluetooth devices are found, the phone will display "BlueAnt V1". Scroll to it and press OK to confirm that you want to Pair with it. Enter Passkey "0000" when your phone prompts you. An additional security setting in your phone may be needed to allow the headset and phone to connect automatically without confirmation each time you connect your V1. If required for first time connection, select the BlueAnt V1 to connect with your phone. After powering ON, your headset will automatically connect to your last used phone if it is in operating range. If this phone is not range, the V1 will enter idle mode after 60 seconds. If no phone has yet been Paired, it will enter the welcome prompt. Enter Pairing Mode: With the V1 OFF, Press and Hold the BAB for about 6 seconds until the LED flashes Blue. The V1 will stay in pairing mode for 2 minutes then will go into idle mode. [. . . ] BlueAnt will replace or repair any faulty product provided it has not been misused or abused in any way. There are no user serviceable parts inside this product. The Warranty is valid for 2 years (24 months) from the date of purchase. (excluding the ComplyTM Foam Tips) · Proof of purchase must be provided to obtain warranty service. [. . . ]