User manual BLUETREK CRESCENDO

[. . . ] · Press the main button for 5 sec. LED light You will hear the welcome message : "Hi, Welcome to the Bluetrek Crescendo headset with the BlueGenie Voice Interface. [. . . ] NOTE : If you have set a favorite number in the mobile phone's speed dial list and headset favorite list at same position, when you say the "Call favorite" command, the number saved in the headset will be taken finally. * If you want to remove all favorite numbers set under the headset, you can reset the software by pressing the Main button together with "Vol+" button for around 7 seconds. Voice Command The following is a comprehensive list of the available commands. At any time you can use the "What Can I Say" command to listen the available commands. Phone command Check Battery Redial Call Back Call Information Say this to. . . Tell you all available commands Enter the pairing mode Tell you if connected to a phone Connect to phone's voice recognition function (if mobile phone supported) Tell you the status of the headset's battery level Dial the last dialed number Dial the last received number Connect to Bing411 voice search center English 4 I BLUETREK CRESCENDO English Call Voice mail/ Favorite 1 Call Favorite 2 Call Favorite 3 Call Favorite 4 Call Favorite 5 Call Home Call Office Traffic Conditions Answer Ignore Settings Menu Cancel Yes No Call number preset on Speed Dial 1 Call number preset on Speed Dial 2 Call number preset on Speed Dial 3 Call number preset on Speed Dial 4 Call number preset on Speed Dial 5 Call number preset on Speed Dial 6 Call number preset on Speed Dial 7 Connect to local 511 center for Traffic conditions Answer the incoming call Reject the incoming call Enter to setting menu Cancel the active operation Answer "yes" for yes/no question Answer "no" for yes/no question BLUETREK CRESCENDO I 5 Multi-point function Multipoint technology which allows you to use one headset with two different Bluetooth mobile phone simultaneity. Please see the instructions as below: Enable the multi-point function 1. Pair the headset to the mobile A (Please refer to "pairing" section). Long press the Vol + and the Vol - button together on the headset under stand-by mode, when heard a "beep", release the buttons and you will hear "Multi-point on" prompt to finish, the multi-point function will be enabled. Press Main button and the Vol - button together to reset the hardware, the headset will turn off automatically. Press and hold the Main button for about 5 seconds to enter into pairing mode, then pair it to the mobile B. (Please refer to "pairing" section). Two mobiles will be connected with the headset automatically. English 6 I BLUETREK CRESCENDO Disable the multi-point function Long press the Vol + and the Vol - button together on the headset under stand-by mode, when heard a "beep", release the buttons and you will hear "Multi-point off" prompt to finish, the multi-point function will be disabled. Answer a call while talking on the other paired phone · To answer the second call and put the current call on hold, double press the Main button to swap · To answer the second call and terminate current call , press once on the Main Button *To avoid issues switching between calls, suggest using the call control button on the headset rather than your phone controls. English BLUETREK CRESCENDO I 7 Settings menu Under settings menu, you can set: · Say a command prompt - Enables or Disables the "Say a command prompt". [. . . ] You can check the compatibility on our website. You can also check with your phone manufacturer that your handset supports either handsfree or headset Bluetooth profiles. [. . . ]