User manual BLUETREK E2

[. . . ] This does not imply that Industry Canada approved the equipment. Bluetooth® is a trademark owned by Bluetooth SIG, Inc. and is used by the manufacturer under license. PAGE 2 / 2 BEFORE USING YOUR HEADSET FOR THE FIRST TIME You must charge it continuously for about 8 hours, until the blue indicator light turns on. Please refer to the "Charging the BLUETREK® E2" section of this manual. Please refer to the "Pairing BLUETREK® E2" section of this manual. Introduction The BLUETREK® E2 headset is a wireless headset based on the Bluetooth® technology. [. . . ] The PIN code (or passkey) is 0000, then press "yes" or "ok". If pairing was successful, the indicator light will switch to blue and flashes slowly. If you haven't started the discovery mode within 5 minutes, the headset will switch off. You must then switch on your headset and start the pairing again. Wearing the BLUETREK® E2 The headset can be worn on either ear by rotating the ear clamp. Make sure the speaker is properly inserted into your ear. Switching the BLUETREK® E2 ON and OFF Switching BLUETREK® E2 ON When your headset is off, press and hold the TALK button for about 2 seconds until the blue indicator light is on. A beep (2 tones) can be heard in the speaker. To check if your headset is ON, press once on the TALK button. If the indicator light flashes blue, it means your headset is ON. Switching BLUETREK® E2 OFF When your headset is on, press and hold the TALK button for about 5 seconds until the red indicator light is on after the quick blue flashes. A beep (2 tones) can be heard in the speaker then release the TALK Button. To save power, the blue indicator light flashes at long intervals. To check if your headset is ON, press shortly on the TALK button. If the indicator light is blue, it means your headset in ON. Making a call Mobile phone with voice recognition . Make sure the voice recognition function on your mobile is activated and your voice tags have been recorded with the phone. To enter these, please refer to your phone's manual . When there is no incoming or active call, press once on the TALK button . Wait for the audio signal sent by the mobile phone (generally a short tone). Speak the name of person you wish to call. PAGE 4 / 4 Mobile without voice recognition . Make sure both the headset and the mobile phone are ON and in stand-by mode. Dial the number on the phone keypad, after approximately 2 seconds the audio connection will be established. This function may not be available on some phones, please refer to the trouble shooting frequent asked questions in our website: www. bluetrek. com. to find out more. Answering a call When the headset rings, press once on the TALK button to take the call. Ending a call Press once on the TALK button to end an active call. Adjusting the volume To increase the volume during an active call, press the "VOL+" button on the headset. [. . . ] Do not expose your headset to liquid or moisture. Do not expose your headset to extreme temperatures. Do not expose your headset to fire or open flames. Service and Maintenance can only be performed by authorized BLUETREK dealers. [. . . ]