User manual BLUETREK MINI

[. . . ] Please refer to the "Pairing the BLUETREK® MINI" section of this manual. English Introduction The BLUETREK® MINI headset is a wireless headset based on the Bluetooth® technology. It complies with Bluetooth® 1. 2 protocol, supporting Headset and Hands-free profile. The BLUETREK® MINI headset has 2 buttons: · "TALK" button (main button) · 1 "VOL+/- " button Charging socket Indicator light TALK button VOL+/- button Microphone 1 I BLUETREK MINI Please connect the charger to the headset and to the main. During the charge, the indicator light is red. [. . . ] Follow the phone instructions to accept the pairing. The PIN code (or passkey) is 0000, then press "yes" or "ok" . Fitting lanyard English 5 I BLUETREK MINI Switching the BLUETREK® MINI ON and OFF Switching BLUETREK® MINI ON When your headset is off, press and hold the TALK button for about 5 seconds until the blue indicator light is on. A beep (2 tones) can be heard in the speaker. Switching BLUETREK® MINI OFF When your headset is on, press and hold the TALK button for about 7 seconds until the red indicator light is on. A beep (2 tones) can be heard in the speaker then release the TALK button. English Making a call Mobile phone with voice recognition . Make sure the voice recognition function on your mobile is activated and your voice tags have been recorded with the phone. To enter these, please refer to your phone's manual. When there is no incoming or active call, press once on the TALK button . Wait for the audio signal sent by the mobile phone (generally a short tone). Speak the name of person you wish to call. BLUETREK MINI I 6 Mobile without voice recognition . Make sure both the headset and the mobile phone are ON and in stand-by mode. Dial the number on the phone keypad, after approximately 2 seconds the audio connection will be established. This function may not be available on some phones, please refer to the trouble shooting frequent asked questions in our website: www. bluetrek. com. to find out more. English Answering a call When the headset rings, press once on the TALK button to take the call. Ending a call Press once on the TALK button to end an active call. Adjusting the volume To increase the volume during an active call, press the "VOL+" button on the headset. To decrease the volume during an active call, press the "VOL-" button on the headset. 7 I BLUETREK MINI To mute the microphone during an active call During an active call, press and hold the VOL+ button for approximately 2 seconds. A periodic tone can be heard in the speaker when the microphone is muted. To end the mute function When the microphone is muted, press and hold the VOL+ button for approximately 2-3 seconds. The periodic tone will end. Transferring a call from BLUETREK® MINI to the mobile phone During an active call, double click on the TALK button. This function only works in the Hands-Free Profile. In the Headset profile, you can simply turn off your headset. Transferring a call from the mobile phone to the BLUETREK® MINI During an active call on the mobile phone, press once on the TALK button to transfer the call. This function may not be available depending on your phone. BLUETREK MINI I 8 English Muting the microphone Fitting the Ergobud* 3 different sizes of Ergobud* are included in the pack to suit your ear size. [. . . ] - Check the regulation in your area if you plan to use your headset while driving. - Turn off your headset before boarding an airplane. CAUTION : Danger of explosion if battery is incorrectly replaced. Dispose of batteries according to local regulations. [. . . ]