User manual BLUETREK S21

[. . . ] Please refer to the "Charging the BLUETREK® S21" section of this manual. Please refer to the "Pairing BLUETREK® S21" section of this manual. Introduction The BLUETREK® S21 headset is a wireless headset based on the Bluetooth® technology. It complies with Bluetooth® 1. 2 protocol, supporting Headset and Handsfree profile. The BLUETREK® S21 headset has 3 buttons: · "TALK "button (main button), · 1 "VOL+ "button, · 1 "VOL- "button. Talk button VOL + button Charging socket Microphone VOL - button Speaker PAGE 1 / 6 PAGE 2 / 6 Charging the BLUETREK® S21 Please connect the charger to the headset and to the mains. [. . . ] Switch on your phone and select its Bluetooth® discover mode (refer to the Bluetooth® mobile phone user manual). When the BLUETREK® S21 is switched off, press and hold the TALK button for about 7 seconds until the indicator light flashes red and blue alternatively. And a sound can be heard in the speaker. Once the mobile phone detects the headset, a "BLUETREK S21" message will be displayed. Follow the phone instructions to accept the pairing. The PIN code (or passkey) is 0000, then press "yes" or "ok". If pairing success, the indicator light will switch to blue and flashes slowly. If you haven't started the discovery mode within 5 minutes, the headset will switch off. You must then switch on your headset and start the pairing again. Flip the ear clamp over, and snap it back onto the headset by applying gentle pressure on the base of the ear clamp ring. Switching the BLUETREK® S21 ON and OFF Switching BLUETREK® S21 ON When your headset is off, press and hold the TALK button for about 2 seconds until the blue indicator light is on. A beep (2 tones) can be heard in the speaker. To check if your headset is ON, press once on the TALK button. If the indicator light flashes blue, it means your headset is ON. Switching BLUETREK® S21 OFF When your headset is on, press and hold the TALK button for about 5 seconds until the red indicator light is on after the quick blue flashes. A beep (2 tones) can be heard in the speaker then release the TALK Button. PAGE 3 / 6 PAGE 4 / 6 Making a call *Mobile phone with voice recognition . Make sure the voice recognition function on your mobile is activated and your voice tags have been recorded with the phone. To enter these, please refer to your phone's manual . When there is no incoming or active call, press once on the TALK button . Wait for the audio signal sent by the mobile phone (generally a short tone). Speak the name of person you wish to call. Make sure both the headset and the mobile phone are ON and in stand-by mode. Dial the number on the phone keypad, after approximately 2 seconds the audio connection will be established. *This function may not be available on some phones, please refer to the trouble shooting frequent asked questions in our website: www. bluetrek. com. [. . . ] Check the regulation in your area if you plan to use your headset while driving. Turn off your headset before boarding an airplane. Muting the microphone To mute the microphone during an active call During an active call, press and hold the VOL+ button for approximately 2 seconds. A periodic tone can be heard in the speaker when the microphone is muted. To end the mute function When the microphone is muted quickly press the VOL+ button on the BLUETREK® S21. [. . . ]