User manual BLUMAX ET-07

[. . . ] Do not place credit cards or other magnetic storage media near the headset, because information stored on them may be erased. Check the model number of any charger before using it with this device. Warning: Use only batteries and chargers approved by the manufacturer for use with this particular enhancement. The use of any other types may invalidate any approval or warranty, any may be dangerous. [. . . ] You only need to pair the headset with your phone for one time. When the headset is connected to the phone and ready for use, the headset beeps, and the blue indicator light flashes every 10 seconds(some flash every 5 seconds). The headset model appears in the phone menu where you can view the current paired Bluetooth devices. Note: If the headset can not connect any compliant mobiles or other devices successfully within 20 minutes after it turns on, the headset will turn off automatically. To disconnect the paired headset from your phone (for example, to connect the phone or headset to another Bluetooth device), turn off the headset, or disconnect the headset from the Bluetooth menu of your phone. You do not need to delete the paired headset from the phone in order to disconnect it. To reconnect the paired headset to your phone: The status of paired headset and phone The paired phone turns on, headset turns off The paired headset turns on, phone turns off If cutting the connection from phone's Bluetooth menu, but headset is still on Both paired headset and phone are on, but out of connection Reconnecting methods Turn on the headset, it will connect with phone automatically Turn on the phone, press the headset MFB button, it will connect automatically or connect from phone's Bluetooth menu. The headset is ready to wear on the right ear ( Pic. If you want to use it on the left ear, please softly lift up the earhook ( Pic 2 ) and rotate it ( Pic. 3), and push it back to the suitable place , then wear to your ear( Pic. The ear hook can be adjusted to suit the different ear size and make you feel comfortable. Warning: Make sure not to distort the ear hook always for a long time with large extent while adjusting the hook, otherwise may damage the ear hook. Note: There are 15 volume levels available for adjusting to high or low, moreover high volume and low volume can be identified by different tone. Whenever it reaches the maxi / mini volume, you will hear two beeps. To Make a Call To make a call, dial the number with your phone, and press the answer key on your phone. If your phone supports redialing function, please press the VL+ key of the headset for 3 seconds, until it beeps then release the VL+key. If your phone supports voice dialing function, press the VL-key of the headset until it beeps, then please release the VL-key. and operate as described in the user guide of your phone. To Answer a Call To answer a call, press the headset MFB or the answer key on your phone. If the automatic answer function is set on in your phone, the phone automatically answers the incoming call after one ring. If you do not want to answer a call, press the headset MFB for 3 seconds until it beeps. To End a Call To end the current active call, press the headset MFB or press the ending key on your phone. [. . . ] A Device with a hot or cold battery may not work temporarily, even when the battery is fully charged. The battery performance will be particularly limited when the temperature is below freezing. Do not dispose the batteries into a fire as they may explode. Pairing: Verify between the two devices (Bluetooth headset and mobile phone) Connect: The two devices build up connection for communication after been approved by each other. [. . . ]