User manual BLUMAX GPS TRACKER V1.0

[. . . ] 0 is a GPS/GPRS based personal tracking device, which is compact and easy to use. 0 has inbuilt GPS module to obtain accurate position data and utilizes its GSM capability to send the position data to a specified mobile phone or server base to allow users to monitor people or pets using the tracker. one unique feature of BLUMAX GPS-Tracker V1. 0 is the inbuilt microphone and loudspeaker that supports two way voice communications like a mobile phone and can be activated either by the guardian calling the tracker or the tracker holder activating the SOS button. [. . . ] 017 is for alarm when tracker moves out the preset scope; 2. Lower-left X should be less than Upper-right X; 5. Only one alarm can be set in either In or Out; 2. Only one alarm can be set in either Movement Alarm or Geo-fence Alarm. Command: W******, 030, T Description: Authorizes a phone number to make a silence call to the tracker, the track answers the call automatically and allows the caller to listen to what happens around the tracker. There is no voice indication that the call is in progress Note: 1. Calls from unauthorized number are treated as normal incoming calls and indicated by beeps. Command: W******, 026, XX Description: Makes the tracker into power down mode when it is inactive or immobile for a period of time. In Power Down states, GPS stops working and GSM enters sleep and stop sending out message until it is activated by message, incoming calls or movement or triggered by three buttons. Notes: XX=00, to turn off this function. XX=01~99, to turn on Power Down after a specified period of being inactive (or stationary). Example: W000000, 026, 10 The tracker will enter power down mode after it is inactive (or stationary) for 10 minutes. Command: W******, 990, 099### Description: This is to make all settings (except for the password) back to factory default. Notes: Turn on the device, press the SOS button for five times continuously and the red LED will be on, and then send (within 120 seconds) this SMS to the tracker. Command: W888888, 999, 666 Description: This is to make the password back to factory default in case you forget your password. Notes: turn on the tracker, press the SOS button for five times continuously and the red LED will be on, and then send this SMS (within 120 seconds) to the tracker to make the password back to factory default (000000). Connect the USB-Serial-Adaptor with your PC (USB) Start the Sofware and choose the right COM-PORT Press start and do your settings Press SOS button and hold, power on the device, when LED solid on, release SOS button and power key. The tracker can be configured by computer using the Parameter Editor. The information contained herein may be changed at any time without prior notification. This manual nor any parts thereof may not be reproduced for any purpose whatsoever without the express written consent of Blumax, nor transmitted in any form either electronically or mechanically, including photocopying and recording. In no event shall Blumax be liable for direct, indirect, special, incidental, or consequential damages (including but not limited to economic loss, such as loss of profits, loss of use of profits, loss of business or business interruption, loss of revenue, loss of goodwill or loss of anticipated savings) arising out of the use or inability to use the product or documentation, even if advised of the possibility of such damages. The tracker will only accept commands from a user with the correct password. [. . . ] Remarks: this command is to set initial characters for SOS message when SOS/IN1, Button B/IN2, Button C/IN3 is pressed. Normally, your country code (for example in China it is +86) will be automatically added and displayed prior to a phone number when sending SMS. In this case, you don't have to do this setting. If the country code is not added, you are required to input the country code, for example, +86, to enable the tracker can send out SMS to your mobile phone. [. . . ]