User manual BOLDER TECH SECURESTART MINI MAX 900

[. . . ] If this warranty card is lost or there are no records of purchase date and name of retailer, the warranty will be void. Please retain this warranty document with proper record. Please refer to page 4 for details. Battery orientation shown here 1 6 IMPORTANT Read All Instructions And Safety Warnings Before Using SecureStartTM Warning / Safety Information 1. Read and follow all instructions in this manual before using the SecureStartTM. [. . . ] To maximize SecureStartTM performance, permanent plugged-in charging is recommended. 5. 6. Plug into the jack here Plug into the cigarette Lighter socket of vehicle 7. On-Charge Display with car adaptor may change color randomly due to fluctuation of alternator voltage. By Wall Adaptor (not provided) - minimum 4 hours or permanently plugged-in charging: Plug the DC jack of the adaptor into the DC charging socket on SecureStartTM. Your SecureStartTM will begin charging upon switching the AC outlet to "ON". To maximize SecureStartTM performance, permanent plugged-in charging is recommended. 8. Do not attempt to disassemble the SecureStartTM. Do not cut any cables or wires on this product. The TMF® power pack contained within your unit is capable of generating very high current. This current may cause severe burns or personal injury. Use your SecureStartTM to jump-start cars that run with lead-acid battery only. Do not jump-start a car that with frozen car battery or attempt to charge it with a SecureStartTM. Never immerse SecureStartTM into water or seawater. Keep SecureStartTM away from sunlight, hot and high humidity environment. Do not store with metal parts such as tools and wires etc. SecureStartTM contains non-spill-able sealed lead-acid batteries. Under normal and appropriate use, the product is safe and there is no exposure to lead. //IMSS103A-E, 20081217// Plug into the jack here Plug into the wall socket On-Charge Display With Wall Adaptor Only: Steady GREEN Indication - Unit is fully charged and ready to GO. Steady RED Indication - Unit is on charge. 2 5 When to Recharge Your SecureStartTM It is mandatory to recharge SecureStartTM immediately after used. SecureStartTM is incorporated with smart charging system as to prevent overcharging. Therefore permanent (float/trickle) plugged-in charging is highly recommended. Simply press and hold the fuel-gauge switch to observe the LED color on the fuel-gauge indicator. GREEN ORANGE/RED/ Audible "Beep" : Ready to jump-start : Immediately recharge your SecureStartTM and replace 13 pieces of AA Alkaline batteries at the same time 5. Turn vehicle ignition switch ON and start the engine. [. . . ] EXCEPT FOR THIS LIMITED WARRANTY, THE MANUFACTURER HAS NOT MADE, AND SPECIFICALLY DISCLAIMS, ANY WARRANTY OR REPRESENTATION OF ANY KIND, EXPRESS OR IMPLIED, DIRECT OR INDIRECT, OF PRODUCT FITNESS FOR A PARTICULAR PURPOSE. THIS LIMITED, CONDITIONAL WARRANTY PROVIDES THE EXCLUSIVE REMEDY FOR ANY CLAIM OR DAMAGE EXCEPT AS OTHERWISE REQUIRED BY LAW. Jump-Starting Your Vehicle NOTE: Use SecureStartTM only on gasoline-powered engines with a 12-volt cranking system. Read all instructions and safety warnings before use. Turn vehicle ignition switch to OFF before accessing battery in vehicle or connecting cable clamps to vehicle battery. [. . . ]