User manual BOMANN VSE 228

[. . . ] Page 14 Special safety Information for this Unit. We hope you will enjoy using the appliance. Symbols in these Instructions for Use Important information for your safety is specially marked. it is essential to comply with these instructions to avoid accidents and prevent damage. [. . . ] Tilt the appliance slightly backwards and block it in this position. Loosen the lower hinge pin and put it in the opposite bracket. Insert the appliance door on the lower hinge pin and fix the door to the property position. Attach the upper limit plate after you have unscrewed the hinge pin and used it on the other side of the plate. Insert the hinge pin in the hole of the appliance door and tight the plate. Check if the door is arranged vertical as well as horizontal, so that a smooth opening and closing of the door is ensured. The ventilation openings in the furniture base and building must be min. 200 cm2 to ensure that heated air can freely escape. Install the power cord so that the appliance can be easily connected after installation. Slide the appliance into the build-in opening until the stop plate (A) abuts the furniture. Press the rubber seal between the appliance and built-in furniture firmly (on the side without hinge). Push the appliance side, which is located opposite the hinges, against the built-in furniture. Arrange the appliance for a secure, vertical position, fix it with the supplied screws and put the protective cap (B) on. In consideration of the shown distances, hold the guide (a) at the top and bottom inside of the furniture door; mark the positions of the drill holes. After drilling, fix the guide with the screws provided. Insert the cover (c) until it clicks in the guide (a). Fully open the appliance and furniture door and join them together. Slide the bracket (b) in the guide (a) and mark the drill holes. Remove the bracket and drill Ø 2 mm holes with about 8 mm distance to the outer door edge. Put the bracket on again; secure it with the screws provided. If an aligning of the furniture door is necessary, use the slot spacing. Check if the door is arranged vertical as well as horizontal, so that a smooth opening and closing of the door is ensured. [. . . ] The appliance must be dry before restarting operation. cAUTION: · Do not use a wire brush or other sharp, abrasive Do not use any acidic or abrasive detergents. Clean the appliance interior, the exterior surfaces, the accessories and the door seal regularly with warm water and mild detergent. Remove for that the appliance content and storage at a cool location. [. . . ]