User manual BONTRAGER AEROBAR

[. . . ] The length of the life of a part varies according to its design, materials, use, and maintenance. Although lighter parts may, in some cases, have a longer life than heavier ones, it should be expected that light weight, high performance parts require better care and more frequent inspections. Regularly inspect your handlebar for signs of fatigue stress: dents, cracks, scratches, deformation, or discoloration. Large forces can accelerate the fatigue of a material. [. . . ] Position the handlebar to the desired angle, making sure they are centered in the stem. Tighten as in Inspect your handlebar regularly. To adjust the length of the aero extensions 1. Loosen the aero extension clamp bolt(s) on the handlebar just enough that the extensions can be moved. Position the extensions to the desired length, making sure the ends of the extensions are within the clamp area (Figure 3). Tighten as in Inspect your handlebar regularly. To adjust the width of the elbow pads 1. Loosen and remove the elbow pad mounting bolt(s). Position the elbow pads to the desired position, 2. Reinstall the bolts, and tighten as in Inspect your handlebar regularly. To change the handlebar height Adjusting the handlebar height on a direct-connect stem affects the headset bearing adjustment. This procedure requires special tools and training so this should only be done by your dealer. Figure 3- Do not over-extend the aero insertion; the minimum insertion decal must remain exposed behind the clamp Carbon Aerobar installation instructions These instructions are written for an experienced mechanic. If you are not sure of your ability to correctly install this handlebar, or do not have the proper tools for installation, have the handlebar installed by your Bontrager dealer. To remove the old handlebar 1. Before removing the controls, note the path of the cables. 3 3. 6. Use an allen wrench to loosen the clamp screws on the control levers. Loosen and remove the handlebar clamp screws. Remove the handlebar from the clamp. To install the Carbon Aerobar 1. Gradually tighten the handlebar clamp screws until snug. Make sure the gaps at the top and bottom of the stem face plate are even. To install the aero extensions 1. Loosen the aero extension clamp bolt(s) on the handlebar. Gently slide the aero extensions through the clamps. Note that there are left and right aero extensions. Position the extensions to the desired length, making sure the ends of the extensions are within the clamp area (Figure 3). Tighten as in Inspect your handlebar regularly. To install the control levers and bar tape Make sure no part has burrs or deformations which could scratch or damage the handlebar. Slide the levers into position on the handlebar and connect the cables. [. . . ] If this crash occurs within one year from the date of retail purchase, Bontrager offers a crash replacement program, substantially reducing replacement cost. To take advantage of this program, contact us using the information listed above, and ask for the Warranty department. Bontrager Limited Warranty Trek Bicycle Corporation warrants each new Bontrager component against defects in workmanship and materials. This warranty covers· · · · This warranty does not cover- Bontrager Carbon Aerobar for the a period of one year from the date of sale. Normal wear and tear Improper assembly Improper follow-up maintenance Installation of parts or accessories not originally intended for, or compatible with the component as sold · Damage or failure due to accident, misuse, abuse, or neglect · Labor charges for part replacement or changeover This warranty is void in its entirety by any modification of the component or its parts. This warranty is expressly limited to the repair or replacement of a defective item and is the sole remedy of the warranty. This warranty extends from the date of purchase, applies only to the original owner, and is not transferable. [. . . ]