User manual BOSCH BSGL 3126

[. . . ] This instruction manual describes various BSGL3 models, which means that some of the equipment features and functions described may not be available on your model. en Congratulations on your purchase of a Bosch BSGL3 vacuum cleaner. Please keep this instruction manual in a safe place. If you pass the vacuum cleaner on to someone else, please also pass on this instruction manual. [. . . ] B)Push the telescopic tube into the connecting piece of the floor tool until it engages. Press on the locking collar and pull out the telescopic tube to disconnect. Figure 7* To adjust the length of the telescopic tube, adjust the adjusting sleeve/sliding switch in the direction of the arrow and adjust the tube to the required length. Figure 8 Holding the power cord by the plug, pull out the required length and plug it into the mains socket. Disposal information Packaging The packaging is designed to protect the vacuum cleaner from being damaged during transportation. It is made of environmentally friendly materials and can be recycled. Dispose of packaging that is no longer required at an appropriate recycling point. Used vacuum cleaners Used vacuum cleaners still contain many valuable materials. Therefore, please take your used vacuum cleaner to your retailer or recycling centre to be recycled. For current disposal methods, please enquire at your retailer or your local council. As long as they do not contain substances that are not permitted to be disposed of in the household rubbish, you can dispose of them with your normal household rubbish. The mains socket must be protected by at least a 16 amp fuse. If a fuse should blow when you switch on the 8 *Depending on equipment Figure 9 Press the on/off button in the direction of the arrow to switch your vacuum cleaner on/off. Figure 10 Adjust the suction by turning the on/off button in the direction of the arrow. Cleaning the hard-floor brush Figure 17* a) Vacuum from below to clean the brushes. B)Cut through threads and hairs wound round the rollers using scissors. Once you have switched off the vacuum cleaner, slide the catch on the floor tool into the groove on the side of the appliance. Figure 19 The appliance can also be carried using one of the two handles when vacuuming steps, for example. Therefore, you must check the underside of the floor tool at regular intervals. Worn undersides of floor tools may have sharp edges that can damage sensitive hard floors, such as parquet or linoleum. [. . . ] Reinsert the filter holder and clip into place. Replacing the Hepa filter If your vacuum cleaner is equipped with a Hepa filter, this should be replaced once a year. Figure 29* Open the dust bag compartment lid (see Figure 23). Release the Hepa filter by moving the locking lever in the direction of the arrow and remove it from the vacuum cleaner. [. . . ]