User manual BOSCH DHI635 HX

[. . . ] 15 Instructions for use: Appliance description Operating modes This can be achieved if combustion air can flow through non-lockable openings, e. In doors, windows and via the airintake/exhaust-air wall box or by other technical measures, such as reciprocal interlocking, etc. If the air intake is inadequate, there is a risk of poisoning from combustion gases which are drawn back into the room. An air-intake/exhaust-air wall box by itself is no guarantee that the limiting value will not be exceeded. [. . . ] The activated carbon filter is installed above the grease filter(s) in the extractor hood. Insert the two enclosed plastic holders into the right and left sides of the extractor-hood housing and attach each holder with a screw (required only if installing an activated carbon filter for the first time). Replacing the activated carbon filter: During normal operation (1 to 2 hours daily), the activated carbon filter should be replaced approx. The activated carbon filter can be obtained from specialist retailers (see Optional accessories).  To ensure the best possible results, use only original filters. Disposal of the old activated carbon filter: ❑ Activated carbon filters do NOT contain any pollutants, i. Insert the activated carbon filter from below into the extractor-hood housing and lock into position on both sides. Cleaning and care For appliances with a glass plate in the pull-out vapour extractor: ❑ The glass plate is easily removed and can be cleaned in a dishwasher. 20 Cleaning and care Disconnect the extractor hood from the electricity supply by pulling out the mains plug or switching it off at the fuse box.  At the same time as you clean the grease filters, clean off any grease from all accessible parts of the housing. This significantly reduces the fire hazard and ensures that the extractor hood performs as effectively as possible.  Use a hot detergent solution or a mild window cleaner to clean the canopy of the extractor hood.  Do not scrape off any dirt that has dried on but loosen it up with a damp cloth.  Do not use abrasive cleaning agents or sponges that could cause scratches.  Note: Do not use alcohol (spirit) on plastic parts, otherwise the surface may become matt in appearance. Do not use stainless-steel cleaner to clean the operating buttons. stainless steel surfaces: ❑ Use a mild non-abrasive stainless steel cleaner.  Clean the surface in the same direction as it has been ground and polished. Switch off the extractor hood and pull out the mains plug or switch off the electricity supply at the fuse box. Pull out the filter drawer all the way. Clean the operating buttons with a mild 4. replace the bulb (standard filament bulb , max 60 W , E14 bulb holder). [. . . ] 0 If the cupboard depth is greater than 280 mm, the hood can be mounted further back, . II Position the template O further back. Align and screw on the enclosed mounting rails. If the hinges are no longer accessible when the extractor hood has been installed, align the cupboard doors. [. . . ]