User manual BOSCH DHI 645F/01 INSTALLATION INSTRUCTIONS

[. . . ] Note: When assessing the overall requirement, the combined ventilation system for the entire household must be taken into consideration. This rule does not apply to the use of cooking appliances, such as hobs and ovens. Unrestricted operation is possible if the extractor hood is used in recirculating mode – with activated carbon filter. Wall cupboard Filter drawer Ventilator switches Light switch Operating modes Exhaust-air mode: ❑ The extractor-hood fan extracts the kitchen vapours and conveys them through the grease filter into the atmosphere. [. . . ] Then brush them off, rinse thoroughly and allow to drip dry.  To ensure the best possible results, use only original filters. removing and installing the filter frames Removal: 1. Pull out the filter drawer all the way. Press the detents on the filter frames all the way in the direction of the arrow.  If there are two grease filters, remove the front one first. Fold the filter frame down at the side and remove. Pull out the filter drawer all the way. Insert the filter frame at an angle into the holder, fold up and attach by pressing the detent all the way.  If there are two grease filters, first insert the rear filter frame and then the front filter frame (profiled edge) into the filter drawer. Ensure that the grease filters are securely positioned on both sides. replace the bulb (standard filament bulb , max 60 W , E14 bulb holder). Do not use any of the following to clean stainless steel surfaces: abrasive sponges, cleaning agents containing sand, soda, acid or chloride!Aluminium, painted and plastic surfaces: ❑ Use a soft, non-linting window cloth or micro-fibre cloth. Plug appliance into mains again or switch on at the fuse box. 21 Installation Instructions: Important information ṇ Old appliances are not worthless rubbish. Valuable raw materials can be reclaimed by recycling old appliances. Before disposing of your old appliance, render it unusable. Additional information concerning gas cookers: ṇ When installing gas hotplates, comply with the relevant national statutory regulations (e. Please ask your dealer or inquire at your local authority about current means of disposal. Always comply with the currently valid ṇ Only one side of the extractor hood may be installed next to a high-sided unit or high wall. Between the upper edge of the trivet and lower edge of the extractor hood: 650 mm, Fig. [. . . ] Mark two points – right and left – on the inside of the cupboard where the hood is to be mounted, and start the hole with a gimlet. Attention: II ❑ Use enclosed template O for marking points where hood is to be mounted.  The mounting points shown on the template have been configured in such a way as to allow a 20 mm thick handle to be attached flush with the front edges of the cupboard. ❑ A stop allows the handle (Dimension ∆) to be positioned further forwards. [. . . ]