User manual BOSCH DHI965VGB INSTALLATION INSTRUCTIONS

[. . . ] An air-intake/exhaust-air wall box by itself is no guarantee that the limiting value will not be exceeded. Note: When assessing the overall requirement, the combined ventilation system for the entire household must be taken into consideration. This rule does not apply to the use of cooking appliances, such as hobs and ovens. Unrestricted operation is possible if the extractor hood is used in recirculating mode ­ with activated carbon filter. Wall cupboard Filter drawer Ventilator switches Light switch Operating modes Exhaust-air mode: The extractor-hood fan extracts the kitchen vapours and conveys them through the grease filter into the atmosphere. [. . . ] Ensure that the grease filters are securely positioned on both sides. 6 Filters and maintenance Activated carbon filter: For filtering odours during circulating-air mode. The activated carbon filter is installed above the grease filter(s) in the extractor hood. Remove the grease filter(s) (see Filters and maintenance). Insert the two enclosed plastic holders into the right and left sides of the extractor-hood housing and attach each holder with a screw (required only if installing an activated carbon filter for the first time). Removal: The activated carbon filter is removed in reverse sequence. Replacing the activated carbon filter: During normal operation (1 to 2 hours daily), the activated carbon filter should be replaced approx. The activated carbon filter can be obtained from specialist retailers (see Optional accessories). To ensure the best possible results, use only original filters. Disposal of the old activated carbon filter: Activated carbon filters do NOT contain any pollutants, i. e. they can be disposed of as household rubbish. 3. Insert the activated carbon filter from below into the extractor-hood housing and lock into position on both sides. Before disposing of your old appliance, render it unusable. You received your new appliance in a protective shipping carton. All packaging materials are environmentally friendly and recyclable. Please contribute to a better environment by disposing of packaging materials in an environmentally-friendly manner. Please ask your dealer or inquire at your local authority about current means of disposal. The extractor hood can be used in exhaust air or circulating air mode. Always mount the extractor hood over the centre of the hob. Minimum distance between electric hob and bottom edge of extractor hood: 430 mm, Fig. The extractor hood must not be installed over a solid fuel cooker ­ a potential fire hazard (e. g. flying sparks) ­ unless the cooker features a closed, non-removable cover and all national regulations are observed. The smaller the gap between the extractor hood and hotplates, the greater the likelihood that droplets will form on the underside of the extractor hood. [. . . ] Mark two points ­ right and left ­ on the inside of the cupboard where the hood is to be mounted, and start the hole with a gimlet. Attention: II Use enclosed template O for marking points where hood is to be mounted. The mounting points shown on the template have been configured in such a way as to allow a 20 mm thick handle to be attached flush with the front edges of the cupboard. A stop allows the handle (Dimension ) to be positioned further forwards. 0 If the cupboard depth is greater than 280 mm, the hood can be mounted further back, . [. . . ]