User manual BOSCH GASCONVERSIONKIT

[. . . ] · Do not use these instructions or the materials contained in the Bosch Clothes Dryer Gas Conversion Kit for any other purpose than that for which they are intended, which is the conversion of the Bosch Gas Clothes dryer from operation with natural gas to operation with propane (LP gas). · Follow these instructions carefully to minimize the risk of death and/or serious injury by fire and/or explosion. [. . . ] Use caution when removing the assembly from the dryer. 23) Remove the burner bracket/ gas valve/igniter/burner assembly from the dryer. 24) Once the burner assembly has been removed from the dryer, remove the two screws that fasten the burner to the burner bracket as shown in Figure 18. Set the screws aside for reinstallation later. Figure 15 26) Remove the burner ring. NOTE: The burner ring will not be installed on the dryer when the dryer is converted for use with propane. However, retain the burner ring for reinstallation should the dryer be reconverted for use with natural gas. 27) Remove the three screws that secure the natural gas valve to the burner bracket as shown in Figure 20. Set the screws aside for reinstallation later. Figure 20 21) Use the service access to locate and remove the screw from the side of the burner bracket as shown in Figure 16. Set the screw aside for reinstallation later. Figure 18 Figure 16 WARNING 25) Remove the two screws that fasten the burner ring to the burner as shown in Figure 19. Set the screws aside for reinstallation later. FIRE/INJURY HAZARD: INSTALLING A NON-LP GAS VALVE IN AN LP GAS SYSTEM CAN CAUSE FIRE. MAKE CERTAIN THAT THE LP GAS VALVE IS INSTALLED WITH THE LP GAS CONVERSION. 28) Identify the LP gas valve by the label reading 25MO1A Type 190 at the top, and Reg. 29) Replace the natural gas valve with the supplied LP valve. [. . . ] Disconnect the manometer and replace the pressure tap with the plug. 45) Leak check the dryer prior to operation. Turn on the gas supply. [. . . ]