User manual BOSCH GIN38A55GB

[. . . ] it has been designed for preserving food. The following instructions are for your own safety and should be observed without fail. We can neither be held responsible, nor uphold the guarantee in case of failure to observe these recommendations, which may lead to material damage or physical injury. - This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. [. . . ] Once you have installed your appliance, adjust its feet so that it is tilting backwards slightly: this helps the door to close correctly. Before placing any food in your appliance, clean it inside and out with a bicarbonate of soda solution (1 dessertspoon of bicarbonate to 4 litres of water). Do not use alcohol, scouring powder or detergents, which could damage the surfaces. - For appliances approximately 180cm in height: to ensure your appliance's stability and prevent it from possibly toppling over, you must use the anti-toppling clamps supplied with the accessories. Figures A and B show how to install these clamps: they must be fixed in the corners on the back of the appliance using the screws supplied with the accessories and also fixed to the wall, behind the refrigerator using a wall fixing specially selected by the user to suit the type of wall (e. For your own safety, you must comply with the instructions given below. The electrical installation must comply with Standard NF C *15-100, in particular concerning the Earth. 5 mm², 230V single-phase connected to: - A 20A single-phase 230V-50Hz supply - An ELCB and an individual fuse (10 or 16A depending on the model) We cannot be held responsible for any incident caused by faulty electrical installation. Recommendations for the electrical installation of your appliance: - Do not use extension leads, adaptors, or socket strips. - Always make sure your circuit is earthed. - The socket must always remain accessible, yet be out of the reach of children. When this function is activated, the symbol appears instead of the refrigerator temperature. To switch on the function, press and hold down the "Child Lock" button (7) for at least 3 seconds. To switch off the function, press and hold down the "Child Lock" button (7) for at least 3 seconds and the letters CL will disappear from the display. An audible beep will let you know that your refrigerator door has been open for at least 60 seconds. To make the beep stop, press any button (+/-) or close the door. The light will remain on until the door is closed. If this signal appears instead of the temperature, it means that the temperature sensor are probably defective. A safety procedure starts automatically to ensure that the appliance can operate but the Technical Assistance Department must be called. If this letter appears in place of the temperature, it means that there is a problem with the electricity supply. ATTENTION Your refrigerator's internal temperature is strictly dependent on the ambient temperature, how frequently the appliance's door are opened and the amount and the temperature of the food you have placed in the refrigerator. You must therefore regularly check the temperature indicator on your refrigerator and adjust the temperature setting if necessary. [. . . ] These noises are as follows: NOISE Buzzing Gargling or slight buzzing Clicks Slight background noise CAUSE Coming from the motor. This buzzing may briefly be louder when the motor starts. Coming from circulation of the refrigerant in your refrigerator's pipes. These can always be heard when the thermostat turns the motor on or off. [. . . ]