User manual BOSCH GWS 24-230 JBV

[. . . ] cluttered or dark areas invite accidents. B) Do not operate power tools in explosive atmospheres, such as in the presence of flammable liquids, gases or dust. Power tools create sparks which may ignite the dust or fumes. C) Keep children and bystanders away while operating a power tool. [. . . ] Hold the power tool only by the insulated gripping surfaces when performing an operation where the cutting tool may contact hidden wiring or its own cord. Contact with a "live" wire will also make exposed metal parts of the power tool "live" and shock the operator. A workpiece clamped with clamping devices or in a vice is held more secure than by hand. Dust from light alloys can burn or explode. Always wait until the machine has come to a complete stop before placing it down. The tool insert can jam and lead to loss of control over the power tool. English | 17 Never use the machine with a damaged cable. Do not touch the damaged cable and pull the mains plug when the cable is damaged while working. damaged cables increase the risk of an electric shock. 16 Bolt hole 17 Positioning pin/mark 18 Lead for the parallel guide 19 Locking screw for parallel guide* 20 Parallel guide with circle cutter* 21 Centring tip of the parallel guide* Read all safety warnings and all instructions. Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury. Danger of injury when touching the saw blade. Selecting a Saw Blade An overview of recommended saw blades can be found at the end of these instructions. The saw blade should not be longer than required for the intended cut. Use a thin saw blade for narrow curve cuts. Before inserting the saw blade 9, set the adjusting lever for orbital action 6 to setting III. ­ Press the orange pushbutton in the rotatable top handle 1 down until it can be felt to engage. ­ Insert the saw blade 9 lateral to the cutting direction into the stroke rod 11. ­ Turn the saw blade 9 so that the toothing faces toward the cutting direction. Pull the saw blade 9 a little downward until it engages. ­ Turn the rotating handle 1 in the direction of the arrow until a click can be heard. ­ Push up the orange pushbutton at the rotatable top handle 1 again to the starting position. [. . . ] Remove the saw blade from the machine and allow the machine to cool down by running it for approx. When working small or thin work pieces, always use a sturdy support or a saw table (accessory). Check wood, press boards, building materials, etc. Attach the rotatable top handle 1 and press downward until it can be felt to engage. [. . . ]