User manual BOSCH HINGEREVERSAL

[. . . ] DOOR HINGE REVERSAL KIT INSTRUCTIONS Your Bosch clothes dryer leaves our factory with its door hinged on the right side. [. . . ] 5) Grasp the dryer door, lift it slightly, and remove it from its hinge as shown in Figure 3. 3. Procedure NOTE: Throughout these instructions, the phrases "right side" and "left side" refer to the dryer and dryer door as seen when you are facing the front of the dryer with the dryer door shut. Figure 3 A. Remove and Prepare the Dryer Door 1) Open the dryer door as far as it will open. 2) Remove the four screws that secure the hinge coverplate as shown in Figure 1. 11) Take the supplied right-side version striker coverplate and insert the latch into it as shown in Figure 6. Figure 6 Figure 1 6) Set the dryer door on a work surface. 7) Remove the two screws that secure the striker coverplate to the dryer door's left side as shown in Figure 4. Figure 4 3) Set the four screws aside. 1 12) Place the right-side version striker coverplate/latch assembly on the dryer door's right side as shown in Figure 7. 3) Lift the hinge and remove it from the dryer's right side as shown in Figure 10. Figure 10 Figure 7 7) Use a small flat head screwdriver to pry the bottom hinge hole cover from the dryer's left side. Lift the bottom hinge hole cover slightly, and remove it as shown in Figure 12. Figure 12 13) Retrieve the two striker coverplate screws and use them to secure the rightside version striker coverplate/latch assembly to the dryer door's right side as shown in Figure 8. Figure 8 4) Set the hinge aside. 5) Use a small flat head screwdriver to pry and remove the two spacer nuts from the dryer's right side as shown in Figure 11. Figure 11 B. Prepare the Dryer 1) Remove the two screws that secure the hinge to the dryer's right side as shown in Figure 9. Figure 9 7) Set the bottom hinge hole cover aside. 6) Set the spacer nuts aside. 2) Set the two screws aside. 2 9) Use a small flat head screwdriver to pry the top hinge hole cover from the dryer's left side. [. . . ] Install the Dryer Door 1) Retrieve the dryer door, position it over the hinge as shown in Figure 20, and drop it into place. 3) Retrieve the four screws from the right-side hinge coverplate, and use them to secure the left-side hinge coverplate as shown in Figure 22. Figure 24 Figure 22 Figure 20 7) Insert a small flat head screwdriver into the holes to lift and remove the signal strips as shown in Figure 25. Figure 25 4) Swing the dryer door several times through its range of motion to check for smooth operation. 4 8) Change the positions of the signal strips so that the red signal strip is on dryer door's right side and the white signal strip is on the dryer door's left side as shown in Figure 26. Figure 26 5 [. . . ]