User manual BOSCH MCM 4100

[. . . ] . aus Safety instructions Delivery Immediately check the packaging and dishwasher for any damage which may have been caused in transit. Do not use a damaged appliance, but consult your supplier. Please dispose of packaging material properly. The corrugated cardboard consists mainly of waste paper. [. . . ] The values can vary considerably according to: different amounts of dishes temperature of mains water supply pressure of mains water supply ambient temperature fluctuations in mains voltage machine-related factors (e. g. Energy and water consumption is reduced by up to 1/4 when dishes are washed in the upper basket only. Water consumption values are based on a water hardness setting of 4. End of programme The end of programme is indicated by a buzzer. This function can be changed as follows: Hold down the Time delay programme button 3 and switch on the Main switch 1 , then release the buttons. The Time delay button 3 flashes and the digital display indicates the value (loud) which was set at the factory. To change the setting: Press the Time delay programme button 3 . Each depression of the button increases the set value by one; when is reached, the display jumps back to (off). The set value is stored in the appliance. Aquasensor The Aquasensor is an optical measuring device with which the cloudiness of the water in the dishwasher is measured. A photoelectric sensor is used to detect the degree of soiling in the water, caused by dissolved food particles such as egg, fat and rolled oats, etc. The Aquasensor functions during all programmes that include a pre-rinse cycle. If the water is still "clean" at the end of the pre-rinse cycle, then the same water is used for the following wash cycle. Press the A and C buttons simultaneously, and hold them pressed for approx. When it has ended, set the main switch 1 to OFF. To restart the dishwasher, set main switch 1 to ON again and select desired programme. 16 aus Changing the programme It is possible to change the programme within 2 minutes after you have switched the dishwasher on. Should it be necessary to change the programme after this period, the programme cycle that has already been begun (e. g. washing) will be completed first of all. The new remaining time displayed is the sum of the remaining time from the preceding programme cycle and the remaining time attributable to the new programme that has been selected. Additional functions * * on applicable models Pre-Soak * The Pre-Soak programme option serves to perform a pre-soak cycle before the main programme. to be pre-soaked and pre-rinsed in the lower rack. If you wish to pre-soak the dishes, this programme option must be selected by pressing the "Pre-Soak" button before the programme starts. The recommended detergent amount is approx. 5 g poured onto the inside of the door. Quick * Pressing the "Quick" button provides a short wash cycle by curtailing the drying phase and the washing time. The washing and drying performance will be reduced with the Quick programme option. Washing contents of UPPER RACK only * If you have a small number of dishes to wash in the upper rack (e. g. [. . . ] Specifications for the water intake and waste-water drainage, as well as electrical connections, must fulfil the criteria that are set out in the following paragraphs and the installation instructions. When installing the dishwasher, carry out tasks in the following order: ­ check contents of delivery upon receipt, ­ site dishwasher, ­ connect drainage hose, ­ connect inlet hose to water supply, ­ connect dishwasher to electricity supply. Fresh-water connection Connect the inlet hose to a water tap using the enclosed parts and in accordance with the installation instructions. Water pressure: Minimum 0, 5 bar ­ maximum 10 bar. If the water pressure is higher, install a pressure reducing valve. [. . . ]