User manual BOSCH NCT616C01 INSTALLATION INSTRUCTIONS

[. . . ] cluttered or dark areas invite accidents. B) Do not operate power tools in explosive atmospheres, such as in the presence of flammable liquids, gases or dust. Power tools create sparks which may ignite the dust or fumes. C) Keep children and bystanders away while operating a power tool. [. . . ] Do not operate the saw if lower guard does not move freely and close instantly. Never clamp or tie the lower guard into the open position. If saw is accidentally dropped, lower guard may be bent. Raise the lower guard with the retracting handle and make sure it moves freely and does not touch the blade or any other part, in all angles and depths of cut. check the operation of the lower guard spring. If the guard and the spring are not operating properly, they must be serviced before use. Lower guard may operate sluggishly due to damaged parts, gummy deposits, or a build-up of debris. Lower guard should be retracted manually only for special cuts such as "plunge cuts" and "compound cuts". Raise lower guard by retracting handle and as soon as blade enters the material, the lower guard must be released. For all other sawing, the lower guard should operate automatically. Always observe that the lower guard is covering the blade before placing saw down on bench or floor. Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury. The machine is intended for lengthways and crossways cutting of wood with straight cutting lines as well as mitre cuts in wood while resting firmly on the workpiece. With suitable saw blades, thin-walled non-ferrous metals, e. Working ferrous metals is not permitted. Circular Saw Article number Rated power input No-load speed Cutting depth, max. ­ for 0° bevel angle ­ for 45° bevel angle Spindle lock CutControl Dust/chip box Base plate dimensions Saw blade diameter, max. Mounting bore Weight according to EPTA-Procedure 01/2003 Protection class mm mm mm mm mm kg ­ ­ 288 x 153 160 150 1. For lower voltage and models for specific countries, these values can vary. Please observe the article number on the type plate of your machine. The trade names of the individual machines may vary. pKS 66 A/NCT616C01F: Starting cycles generate brief voltage drops. [. . . ] Note: On the workpiece side where the cut is being started, the guide rail 31 must always face flush against the workpiece, and may not project beyond it. Should the guide rail 31 project beyond the workpiece end, do not rest the circular saw on the guide rail 31 without holding the circular saw. The guide rail 31 is made of plastic and cannot hold the circular saw. Fasten the guide rail 31 to the workpiece using the special screw clamps 30. [. . . ]