User manual BOSCH PBH 2100 SRE

[. . . ] Book Page 16 Friday, November 19, 2010 2:46 PM 16 | English Safety Notes en General Power Tool Safety Warnings WARNING Read all safety warnings and all instructions. Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury. Save all warnings and instructions for future reference. The term “power tool” in the warnings refers to your mains-operated (corded) power tool or battery-operated (cordless) power tool. [. . . ] Technical Data Rotary Hammer Article number Speed control Stop rotation Right/left rotation Delivery Scope – Key type drill chuck Rated power input Output power Impact rate Impact energy per stroke according to EPTA-Procedure 05/2009 Speed Tool holder Spindle collar diameter Drilling diameter, max. : – Concrete – Steel – Wood Weight according to EPTA-Procedure 01/2003 Protection class mm mm mm mm kg W W min -1 PBH 2000 RE 3 603 C44 3. 2 / II J min-1 The values given are valid for a nominal voltage [U] of 230 V. For different voltages and models for specific countries, these values can vary. Please observe the article number on the type plate of your machine. The trade names of the individual machines may vary. Book Page 20 Friday, November 19, 2010 2:46 PM 20 | English Adjusting the Drilling Depth (see figure B) The required drilling depth X can be set with the depth stop 12. € Press the button for the depth stop adjustment 9 and insert the depth stop into the auxiliary handle 11. The knurled surface of the depth stop 12 must face downward. € Insert the SDS-plus drilling tool to the stop into the SDS-plus tool holder 1. Otherwise, the movability of the SDS-plus drilling tool can lead to incorrect adjustment of the drilling depth. € Pull out the depth stop until the distance between the tip of the drill bit and the tip of the depth stop correspond with the desired drilling depth X. Declaration of Conformity We declare under our sole responsibility that the product described under “Technical Data” is in conformity with the following standards or standardization documents: EN 60745 according to the provisions of the directives 2004/108/EC, 2006/42/EC. 2010 Selecting Drill Chucks and Tools For hammer drilling and chiselling, SDS-plus tools are required that are inserted in the SDSplus drill chuck. For drilling without impact in wood, metal, ceramic and plastic as well as for screwdriving, tools without SDS-plus are used (e. For these tools, a keyless chuck or a key type drill chuck are required. Assembly Before any work on the machine itself, pull the mains plug. Auxiliary Handle Operate your machine only with the auxiliary handle 11. Changing the position of the auxiliary handle (see figure A) The auxiliary handle 11 can be set to any position for a secure and low-fatigue working posture. € Turn the wing bolt for adjustment of the auxiliary handle 10 in anticlockwise direction and set the auxiliary handle 11 to the required position. Then tighten the wing bolt 10 again in clockwise direction. Changing the Key Type Drill Chuck To work with tools without SDS-plus (e. [. . . ] € Turn the mode selector switch 8 to the “Vario-Lock” position (see “Setting the Operating Mode”, page 22). € Turn the tool holder to the desired chiselling position. € Turn the mode selector switch 8 to the “chiselling” position. Com After-sales Service and Customer Assistance Our after-sales service responds to your questions concerning maintenance and repair of your product as well as spare parts. [. . . ]