User manual BOSCH PCH615B80E

[. . . ] Additional information on products, accessories, replacement parts and services can be found at www. The manufacturer is exempt from all responsibility if the requirements of this manual are not complied with. You will only be able to use your appliance safely and effectively when you have read them. These operating and installation instructions should be retained, and passed onto the buyer if the appliance is sold. [. . . ] If after 15 seconds the flame does not ignite, switch off the burner and open a nearby window or door. Wait at least one minute before trying to switch the burner back on. safety system Depending on the model, your hob may have a safety system (thermocouple) that prevents the flow of gas if the burners accidentally switch off. The hob may have a main switch to cut off the mains gas supply and switch off all the burners at the same time. This switch is very practical if there are children in the house or, if for any reason, all the burners must be switched off quickly. This switches off all the burners which are on. Without releasing the control knob, press and hold it down Firmly for 4 seconds after lighting the flame. Turn the corresponding control knob clockwise to the 0 setting. The progressive control knobs can be used to control the power needed, from minimum to maximum power. For dual double-flame burners, the inner and outer flames can be controlled separately. The available power levels are as follows: Turn all the control knobs to the "off" position. Press the main switch and turn it fully clockwise. warnings It is normal to hear a soft whistling noise while the burner is operating. When first used, it is normal for the burner to give off odours. This does not pose any risk and does not indicate a malfunction. This is caused by the presence of dust in the atmosphere, spilt liquids, etc. If the burner flames are accidentally blown out, switch off the burner operating control knob and do not try to relight it for at least 1 minute. A few seconds after the burner is switched off, a sound (thud) will be produced. This is not a fault - this means that the safety device is no longer operating. If the ignition sparkers are dirty they will not light properly. Clean them periodically using a small non-wire brush. Bear in mind that the ignition sparkers must not suffer any serious impacts. [. . . ] Always clean off any liquid as soon as it is spilt. The burner immediately The control knob was not held down for long The grooves on the burner are dirty. Once the burner is on, hold the control knob down a few seconds longer. When contacting our Technical Assistance Service, please provide the product number (E-Nr. [. . . ]