User manual BOSCH PCQ715B80E/07

[. . . ] 8 Installation of cooktop into the kitchen bench . 12 To change injectors 12 For your safety What to do if you smell gas Warnings Changing the nozzles of the burners on the cooktop . . 15 15 15 16 16 16 16 17 18 18 18 19 20 21 21 21 21 22 23 3 Dear customer, Congratulations on your choice and thank you for purchasing one of our appliances. This practical, modern and functional appliance is manufactured using materials of the highest quality which are subject to strict quality control checks throughout the entire manufacturing process. [. . . ] 4. Gas During the planning stage, consider the position of supply connections. The cooktop must be connected to the gas supply with upstream connection of an isolation valve in accordance with the respectively valid regulations. We recommend that the isolation valve be fitted prior to the cooktop to enable isolation of cooktop from gas supply. The valve must be easily accessible at all times. To find out the factory set gas type, see bottom of cooktop next to gas connection. Remove plastic cap from gas supply line prior to installation. Fit regulator (N. G. ) or a test point (Universal LPG) directly to the R 1/2'' connection as per Fig. Direction of gas flow is indicated on the rear of the regulator. For position of the inlet connection refer Fig. 1. Use pipe compound or thread sealant, properly theaded pipes and careful assembly procedure so that there is no cross threading, etc. , which might cause damage or leakage. Make sure that all connections peformed are free of leakage. 10 To assemble the grease splash tray again, proceed in the reverse order to removal. It is important that all the seals are refitted to form a seal. These devices are essential for the correct operation of the appliance as they prevent liquids and dirt from entering the appliance. In the event of a malfunction, change the whole tap. Fig. After finishing, the sticker indicating the new type of gas must be placed close to the specifications plate. 14 Operating instructions Burner locations 4 1 5 4 1 5 6 2 3 3 2 7 4 1 2 3 4 5 6 7 Pan supports Control knobs Auxiliary burner (up to 1 kW) Semi-rapid burner (up to 1, 75 kW) Rapid burner (up to 3 kW) Double-flame burner (up to 3, 3 kW) Triple-flame burner (up to 4 kW) There are indications to show which burner each control knob operates. 12 The gas burners Operation It is essential to ensure that all the burner parts and pan supports are correctly installed for the appliance to work correctly. 14 Switching on automatically If your cooktop can be switched on automatically (ignition sparkers): 15 1. Press the chosen burner control knob and turn it anticlockwise to the maximum power setting. While the control knob is still pressed down, sparks are produced on all burners. The flame ignites (it is no longer necessary to press down the control knob). Turn the control knob to the required setting. [. . . ] Where possible, do not allow salt to come into contact with the surface of the electric hob. The ring cover of the double or triple flame burner and stainless steel parts such as hotplate rings, top sheet and the area around the burners may become discoloured over time. This is normal because of the high temperatures. Each time the appliance is used these parts should be cleaned with a product that is suitable for stainless steel. [. . . ]