User manual BOSCH PFZ 600

[. . . ] contacting electric lines may cause fire or electric shock. Striking a gas line will probably result in explosion. Breaking into a water pipe will cause property damage or may cause an electric shock. S Connect machines that are used in the open via a residual current device (RCD) with an actuating current of 30 mA maximum. [. . . ] B) Loosen the Allen screw 11 with the Allen key 10. Insert the saw blade 1 between the stroke rod 9 and the clamping plate 8. Take care that the securing pin of the stroke rod 9 engages in the hole of the saw blade (Saw blade cannot be pulled out). Before putting into operation, check the saw blade for secure seating. Check for correct mains voltage: The voltage of the power source must agree with the voltage specified on the nameplate of the machine. Equipment marked with 230 V can also be connected to 220 V. Light application of pressure on on/off switch 6 results in low stroke rate. Increasing pressure results in a higher stroke rate. A selection of the illustrated or described accessories can be found at the end of the operation manual. The required stroke rate can be preselected (also during operation) using the thumbwheel 7. After working for longer periods at low stroke rate allow the machine to cool down by running it at maximum stroke rate and no-load for approx. S Before any work on the machine itself, pull the mains plug. Wear protective gloves to avoid injury from the sharp cutting edges of the saw blade both during assembly as well as when checking afterwards. When changing the saw blade, take care that the blade holder is free of material residue (e. By means of the adjustable orbital action, the contact of the saw blade can be adapted to the material to be worked. The saw blade is lifted from the workpiece on the downward stroke which improves chip ejection and increases the service life of the saw blade. The orbital action can be selected in 4 steps with the knob 4. The switching can be made with the machine running: If the saw blade seizes, switch machine off immediately. Spread gap somewhat with suitable tool and pull out saw blade. When using tools such as files and rasps or to achieve clean cutting edges. D / E) Plunge cutting may only be used on soft materials, such as wood, aerated concrete, gypsum plaster boards, etc. However, this requires a certain practise and is only possible with short saw blades. [. . . ] If the machine should fail despite the care taken in manufacturing and testing procedures, repair should be carried out by an authorized after-sales service centre for Bosch power tools. In all correspondence and spare parts orders, please always include the 10-digit order number given on the nameplate of the machine. The wires in the cable are coloured according to the following code: Live = brown neutral = blue Do not connect the blue or brown wire to the earth terminal of the plug. Important: If for any reason the moulded plug is removed from the cable of this machine it must be disposed of safely. [. . . ]