User manual BOSCH PKE691E02E

[. . . ] EN Instruction manualS S S Table of contents Important information . Familiarising yourself with the appliance . 4 4 4 6 8 8 9 9 Main switch with childproof lock . 16 16 17 Procedure in the event of a malfunction . [. . . ] Switch on the hob using the @ main switch. Activating the childproof lock 1. Switch off the hotplates one by one from right to left. 3. Touch the main @ switch for at least 5 seconds. After this time has elapsed, the § indicator lights up for 10 seconds then goes out. Operating the hob To switch on, touch the @ main switch for more than 4 seconds. During this time the § display flashes. As soon as the display goes out, the hob is switched on. You can deactivate the childproof lock again. Proceed in the same manner as for activating the childproof lock. Deactivating the childproof lock 10 Locking the hob once off You can lock the hob on a single occasion, if for example, small children are visiting: The hob must be switched off. Touch the @ main switch for more than 4 seconds. The § indicator lights up for 10 seconds and goes out. Touch the @ main switch for more than 4 seconds. The child proof locks could be activated or deactivated unintentionally when the appliance is cleaned using water or as a result of spillages or objects covering the main switch @. Unlocking once off locking Important Cooking This section describes how to adjust the hotplates. The table shows the heat settings and cooking times for various dishes. You can set the required heat setting using the + and - symbols. Heat setting 1 = lowest setting Heat setting 9 = highest setting. Each heat setting has an intermediate step. This is marked by a dot. The + and - control panels Settings The hob must be switched on. 1. Touch the + or - symbol. 0 flashes in the indicator. 11 2. Touch the + or - symbol in the next 5 seconds. The basic setting will appear: + symbol = heat setting 9 - symbol = heat setting 4 3. To change the heat setting: Touch the + or - symbol until the desired heat setting appears. Changing the heat setting: Switching off the hotplate. You can change the heat setting at any time. From power level 9 you can easily reach level 0 by touching the + symbol twice . The hotplate switches off and the residual heat indicator appears after approximately 5 seconds. 12 Table The following table provides a few examples. [. . . ] If E Ö and numbers appear in the display panels, there is a fault in the electronics. Disconnect the appliance from the mains and reconnect it. Consult the after sales service if the display appears again. 18 F display and numbers If F and a number flash alternately in the display, your appliance is indicating a fault. The following table contains measures for rectifying faults. [. . . ]