User manual BOSCH PST18LI

[. . . ] ς Avoid body contact with earthed or grounded surfaces, such as pipes, radiators, ranges and refrigerators. There is an increased risk of electric shock if your body is earthed or grounded. ς Do not expose power tools to rain or wet conditions. Water entering a power tool will increase the risk of electric shock. [. . . ] Battery Charging (see figure A)  Use only the battery chargers listed on the accessories page. Only these battery chargers are matched to the lithium ion battery of your power tool. note: The battery is supplied partially charged. To ensure full capacity of the battery, completely charge the battery in the battery charger before using your power tool for the first time. Certain dusts, such as oak or beech dust, are considered as carcinogenic, especially in connection with wood-treatment additives (chromate, wood preservative). Materials containing asbestos may only be worked by specialists. € As far as possible, use a dust extraction system suitable for the material. € Provide for good ventilation of the working place. – It is recommended to wear a P2 filter-class respirator. Observe the relevant regulations in your country for the materials to be worked. Dust Cover Mount the dust cover 11 before connecting the machine to the dust extraction. Mount the dust cover 11 onto the machine in such a manner that the centre holder engages on the contact protector 16 and the two outer holders engage in the openings on the casing. Remove the dust cover 11 for applications without dust extraction as well as when performing mitre cuts. For this, push the dust cover together at the two outer holders and pull it off toward the front. 13) Replacing/Inserting the Saw Blade  When mounting the saw blade, wear protective gloves. Danger of injury when touching the saw blade. Selecting a Saw Blade An overview of recommended saw blades can be found at the end of these instructions. Use only T-shank saw blades or saw blades with 1/4" universal shank (U-shank). The saw blade should not be longer than required for the intended cut. Use a thin saw blade for narrow curve cuts. Inserting the Saw Blade (see figure B)  Clean the shank of the saw blade before inserting it. an unclean shank cannot be fastened securely. [. . . ] When being transported by third parties (e. : air transport or forwarding agency), special requirements on packaging and labelling must be observed. For preparation of the item being shipped, consulting an expert for hazardous material is required. Dispatch batteries only when the housing is undamaged. [. . . ]