User manual BOSCH PWS 9-125

[. . . ] Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury. Save all warnings and instructions for future reference. The term “power tool” in the warnings refers to your mainsoperated (corded) power tool or battery-operated (cordless) power tool. Work area safety Keep work area clean and well lit. [. . . ] damaging a gas line can lead to explosion. Penetrating a water line causes property damage or may cause an electric shock. Release the On/Off switch and set it to the off position when the power supply is interrupted, e. , in case of a power failure or when the mains plug is pulled. A workpiece clamped with clamping devices or in a vice is held more secure than by hand. Products sold in GB only: Your product is fitted with an BS 1363/A approved electric plug with internal fuse (ASTA approved to BS 1362). If the plug is not suitable for your socket outlets, it should be cut off and an appropriate plug fitted in its place by an authorBosch Power Tools 2 609 004 687 | (10. Book Page 18 Monday, October 10, 2011 9:22 AM 18 | English Noise/Vibration Information Measured sound values determined according to EN 60745. Typically the A-weighted noise levels of the product are: Sound pressure level 90 dB(A); Sound power level 101 dB(A). The vibration emission level given in this information sheet has been measured in accordance with a standardised test given in EN 60745 and may be used to compare one tool with another. It may be used for a preliminary assessment of exposure. The declared vibration emission level represents the main applications of the tool. However if the tool is used for different applications, with different accessories or poorly maintained, the vibration emission may differ. This may significantly increase the exposure level over the total working period. An estimation of the level of exposure to vibration should also take into account the times when the tool is switched off or when it is running but not actually doing the job. This may significantly reduce the exposure level over the total working period. Identify additional safety measures to protect the operator from the effects of vibration such as: maintain the tool and the accessories, keep hands warm, organise work patterns. Technical Data Angle Grinder Article number Rated power input Output power Rated speed Speed control adjustment Grinding disc diameter, max. thread of grinder spindle Thread length (max. ) of grinder spindle Constant electronic control Speed preselection Weight according to EPTA-Procedure 01/2003 Protection class PWS 8-125 CE 3 603 C99 B. 800 425 11000 2800 – 11000 125 M 14 22 PWS 9-125 CE 3 603 C99 A. 900 450 11000 2800 – 11000 125 M 14 22 W W min-1 min-1 mm mm kg The values given are valid for a nominal voltage [U] of 230 V. [. . . ] Book Page 41 Monday, October 10, 2011 9:22 AM Português | 41 Se não for possível evitar o funcionamento da ferramenta eléctrica em áreas húmidas, deverá ser utilizado um disjuntor de corrente de avaria. Book Page 44 Monday, October 10, 2011 9:22 AM 44 | Português Destravar o interruptor de ligar-desligar e colocá-lo na posição desligada, se a alimentação de rede for interrompida, p. Undgå at bære el-værktøjet med fingeren på afbryderen og sørg for, at el-værktøjet ikke er tændt, når det sluttes til nettet, da dette øger risikoen for personskader. Slibeskiver for afsplintninger og revner, slibebagskiver for revner, slid eller stærkt slid, trådbørster for løse eller brækkede tråde. [. . . ]