User manual BOSCH SGV09T03EU

[. . . ] Household Appliances 9000 040 664 (8402) en Instructions for Use Internet:http://www. bosch hausgeraete. de Bosch Info Team: DE Tel. DTAG) en Index 4 6 7 8 9 10 11 12 15 Opening and closing the door . Selecting options/standard settings Maintenance and care . 17 18 19 19 21 22 28 30 33 33 34 Safety instructions . [. . . ] This starts the time counting backwards. When the set time has elapsed the programme will start automatically. Until the programme starts you are able to change the set time and programme. To do this, use the button ­ 3 to return to the Main Menu and change the settings. In order to delete the pre-selected time, set the time back to "Delay Start: 00mins". Reduce Time The Auto Programmes allow you to reduce the run time of the programmes. However, in order to achieve an optimal cleaning result, the water and energy consumption will be increased. If the option "Reduce Time" is chosen the display shows "Reduce Time: Off" (factory setting). Return to the Main Menu by pressing M/OK 2 and start the required programme by pressing the Start Button 5. If you do not want to use "Reduce Time" the next time you use the dishwasher, you must deselect this option. Drying Level If the option "Drying Level" is chosen the display shows "Normal Drying" (factory setting). Alternatively, you can choose "Save Drying" or "Extra Drying". The option "Extra Drying" increases the temperature during rinsing in all programmes. (Please take care with delicate dishes. ) Remote Control ** After choosing the option "Remote Control" the display will show "Remote Control: Off" (factory setting) You activate this option by selecting "Remote Control: On". ** Only with installed interface Buzzer Volume You can modify the volume of the acoustic signals or even turn it off altogether. If the option "Buzzer Volume" is chosen the display shows "Buzzer 6" (factory setting). You can change this value to 0 (acoustic signals switched off) or to values between 1 (quiet) and 6 (loud). A short buzz demonstrates the currently chosen volume level. 23 en Adding Rinse Aid You can set the amount of rinse aid added. If the option "Adding Rinse Aid" is chosen the display shows "Rinse Aid 4" (factory setting). Change this setting only if there are streaks (reduce the value) or water stains (increase the value) remaining on the dishes. You can choose a value between 0 and 6. Language You can change the language selected when the appliance was started for the first time (see chapter "Before Starting The Device For The First Time"). If the option "Language" is chosen the display shows several language abbreviations. The abbreviation of the currently selected language is flashing. In order to choose a different language, press ­ or + 3 until the desired language appears. [. . . ] Disconnect the waste water and fresh water connections. Loosen the fastening screws under the worktop. Pull out the appliance, carefully pulling the hose behind. Transportation Empty the dishwasher according to the following steps: Turn on the tap. Start any automatic programme and close the appliance door. [. . . ]